Easy Setup menu item
You can scan for unused frequencies using the Easy Setup menu item.
When you have connected multiple EM 100 G4 devices to a network via the
RJ-10 interfaces (see "Creating a data network"), you can perform the fre-
quency setup for all of the connected receivers. You can find more informa-
tion about connecting multiple devices under "Performing multi-channel
frequency setup"
Switch off all transmitters before you perform the scan. If transmit-
ters are still switched on, they are detected as unavailable frequen-
cies and the frequencies that are actually available cannot then be
used.
The squelch threshold setting influences the result. Set the squelch thresh-
old to Low for as many frequencies as possible, and to High for as many
safe frequencies as possible (see "Squelch menu item").
To open the Easy Setup menu item:
On the home screen, press the SET button to open the operating menu.
▷
▷
Press the UP or DOWN button until the Easy Setup menu item appears
in the selection frame.
▷
Press the SET button to open the menu item.
Scan New List
Select Scan New List to scan for unused frequencies.
▷
▷
Press the SET button to start the scan.
The frequency range of the receiver is scanned. As a result, the number
of unused frequencies is displayed for every frequency bank.
Press the UP or DOWN buttons to select a frequency bank.
▷
▷
Press the SET button to confirm your selection.
Press the UP or DOWN buttons to select an unused frequency from the
▷
selected bank.
Using the EM 100 G4
64