Troubleshooting - REIZEN 704066 Instruction Manual

Set Time
Hold S2 (4 o'clock button) while the watch is in normal Time Keeping mode for
1.
more than 5 seconds until the watch says: "Set alarm, press 2 o'clock button (S2)
to set."
Push S2 (4 o'clock button) four (4) more times, until the watch says: "Set Time,
2.
press 2 o'clock button (S1) to set."
Press 2 o'clock button (S1).
3.
The watch says: "Press 2 o'clock button (S1) to set hour, 4 o'clock button (S2) to
4.
confirm."
Press S1 (2 o'clock button) to set Hour. Listen very carefully to the watch to make
certain that AM or PM has been set correctly.
Press S2 (4 o'clock button) to confirm after you have set the Hour.
5.
The watch says: "Press 2 o'clock button (S1) to set minute, 4 o'clock button (S2)
6.
to confirm."
Press S1 (2 o'clock button) to set Minute.
7.
Press S2 (4 o'clock button) to confirm after the minute is set.
8.
9. After confirmation, the watch fast spinning to match the time announcement
automatically.
10. Wait until the watch resumes normal running.
NOTE: Your watch is able to set Date, Day, Month, and Year automatically only
when the radio time signal is available.
Setting Watch To Sleep Mode
You should do this only if you will leave your watch unused in your drawer for a long
period of time.
1. While the watch is running normally, press and hold without releasing S1 (2 o'clock
button).
2. Press and hold S2 at the same time (holding down 2 buttons now) until the second
hand is fast spinning.
3. Release all buttons. The watch will spin to 1:00:00 and then sleep there.
To Wake Up Watch
Press any button for 2 seconds. After the watch is woken up, it will spin to match the
internal time. Wait until the watch resumes normal running.

TROUBLESHOOTING:

Your watch is a delicate and precise instrument. Although uncommon, sometimes hard
knocks or vibrations can cause the hands to move irregularly and display the incorrect
time, even though the internal clock is keeping accurate time. You may notice this when
the time announcement does not match the position of the watch hands. To correct this
situation, you will need to reset the watch hands using the following procedures.
6