Setting Daily Alarm - REIZEN 704066 Instruction Manual

6. After the confirmation, the watch will run to the local time of the country that you
have selected. Wait until the watch stops fast running and resumes normal running.
7. During "Summer Time" or "Daylight Saving Time" there will be a one hour
difference after you have set the watch to a new country. This will be corrected after
the local time signal reception has been updated.
8. The watch will synchronize with the local atomic clock automatically at midnight
starting from 3:00 AM so you have to make sure that the right country has been set or
the watch will not be able to locate the local radio time setting signal.
Manual Signal Reception
The watch must be set to the correct country before using manual signal reception.
Refer to the "Country Signal Selection" section for details.
Place the watch on a table near a window to obtain manual signal reception. Please pay
attention to the position of the watch. You must put the watch on the table according to
the position shown on the picture below or the watch will not be able to acquire the time
signal.
While the watch is running in normal time mode:
1. Hold S1 (2 o'clock button) until the second hand stops.
2. The watch takes about 5 to 14 minutes to pick up the radio signal. Please be patient
and wait until the watch has finished the signal receiving procedure.
3. After signal reception, the watch will show the time again after the fast running of the
second hand has stopped and it has resumed normal running.
4. Push S1 (2 o'clock button) three (3) times after the watch has resumed normal
running to check reception status.
- If time signal reception was successful, the watch says "[Country Name]"
followed by "Time Updated."
- If time signal reception failed, the watch says "[Country Name]" followed by
"Time Not Updated."

Setting Daily Alarm

1. Hold S2 (4 o'clock button) for more than 5 seconds while the watch is in the normal
time mode until the watch says "Set alarm, press 2 o'clock button (S1) to set."
2. Press S1 (2 o'clock button), the watch says "Press 2 o'clock button (S1) to set hour, 4
o'clock button (S2) to confirm."
3. Press S1 (2 o'clock button) to set alarm hour.
4. Press S2 (4 o'clock button) after alarm hour is set.
5. The watch says "Press 2 o'clock button (S1) to set minute, (4 o'clock button (S2) to
confirm."
6. Press S1 (2 o'clock button) to set alarm minute.
7. Press S2 (4 o'clock button) to confirm and exit after you have set the alarm minute.
8. After confirmation, the watch will say the alarm time (Hour and Minute) that you
have set.
4