FSP Technology Nano 400 Quick Manual

Nano UPS Quick Guide
1
Package Contents
You should have received the following items inside of package:
- UPS Unit
Quick Guide
-
-Power cable (only for the IEC-type model)
2
Product Introduction
The Nano UPS provides comprehensive protection in a small and economic package.
The UPS is more compact and offers greater comprehensive power protection against
surges and spikes. This UPS will continue providing stable power to connected
equipment and enable to shutdown PC safely during power failure. Its embedded
microprocessor controller guarantees high reliability and it's perfect for any home
or small office application.
3
Product Overview
Front View:
1
Power switch
1
2
2
UPS status indicator
3
3 Fault/Battery status indicator
(Check the Indicator & Alarm Table for the details)
Back View:
3
1
2
NEMA Type Universal Type Schuko Type
IEC Type
1 AC input
1 3
2 Output receptacles
3
Circuit breaker
2
4 Installation & Initial Startup
V.1.0
NOTE: Before installation, please inspect the unit. Be sure that
nothing inside the package is damaged.
Placement & Storage Conditions
Install the UPS in a protected area that is free of excessive dust and has adequate
air flow. Please place the UPS away from other units at least 20 cm to avoid
interference. Do NOT operate the UPS where the temperature and humidity is
outside the specific limits. (Please check the specs for the limitations.)
20cm
20cm
Connect to Utility and Charging
Before initial use, please p lug in the AC input cord to the
wall outlet and turn on the UPS for charging. For the best
results, suggest to charge the battery at least 8 hours
before initial use. The UPS charges its battery while
connecting to the utility with power on.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply
turn on the power switch of UPS unit, then devices connected to the UPS will
be protected by UPS unit.
CAUTION: NEVER connect a laser printer or scanner to
the UPS unit. This may cause the damage of the unit.
Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by
pressing again the power switch.
Indicators & Alarm Table for Operation
Conditions
AC mode
Battery mode
Low battery at Green LED flashing every
battery mode second & Red LED lighting
Fault
Alarm for over-
Red LED flashing every 0.5
temperature
protection
Visual Indications
Green LED lighting
Green LED flashing
Sounding every 10 seconds
every 10 seconds
Sounding every second
Red LED lighting Continuously sounding
seconds
8 hours
Alarm
Off
Off