Specifications - Rockford Fosgate 250.2 Operation & Installation

250. S
1
PECIFICATIONS
Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4V
Mono into a 4 load
Mono into a 2 load
Bridged (using 2 Punch 250m) into a 4 load
Continuous Power Rating (Competition Standard) – Measured at 13.8 Volts
RMS continuous power mono, into a 4 load from 20-20,000Hz
with less than 0.10% THD
RMS continuous power mono, into a 2 load from 20-20,000Hz
with less than 0.15% THD
RMS continuous power bridged, (using 2 Punch 250.
Power amplifiers in the same system) into a 4 load
from 20-20,000Hz with less than 0.15% THD
Signal-to-Noise Ratio:
Frequency Response:
Bandwidth:
Damping Factor @ 4 (at output connector):
Slew Rate:
IM Distortion (IHF):
Input Impedance:
Source Unit Compatibility (+15dB Gain Overlap):
Input Sensitivity (+0dB Gain Overlap):
Pass-Thru Output:
B+ Fuse Size: (External to amplifier)
Fuse Type:
Crossover Slope:
Factory Crossover Frequency:
Factory Default Crossover Setting:
Dimensions:
*This is the calculated Dynamic Power Rating. Actual output power exceeded the input capability of the PowerCube.
1
Specifications subject to change without notice.
– 47 –
420 Watts
710 Watts
1420 Watts*
250 Watts
500 Watts
1000 Watts
>100dB (A-weighted)
20Hz-20,000Hz 0.5dB
10Hz–250kHz 3dB
>200
50V ms
<0.05%
20k Ohms
28V max. input
Variable from 300mV to 5V
Unity Gain
60 Amp or two 30 Amp
AGU / Maxi Fuse
12dB or 24dB/octave Butterworth
80Hz (0.047mf)
Full Range
9-5/8"W x 14-9/32"L x 2-5/8"H
(24.4cm) x (36.27cm) x (6.6cm)