Wiring The Punch - Rockford Fosgate 100X2 Owner's Manual

Passenger
Compart-
ment
Mounting

WIRING THE PUNCH

Preparing
Wires and
Fuses
Under the seat or floor mounting will work as long as there
is a minimum of 1" (2.5cm) of air gap above the amplifer's
heatsink.
Vertical mounting is still the best, and under dash mount-
ing is satisfactory as well.
Caution! Be sure to avoid running the power wires
near the input cabling antenna, power leads, sensi-
tive equipment or harnesses. The power wires carry
substantial currents and can induce noise.
The following instructions explain how to prepare the
wires for connecting the fuses and connectors. We
suggest you perform these procedures prior to wiring and
mounting your new Punch amplifier.
Wiring the Fuse Holder
1. Cut approximately 18" (45.72cm) off the
wire. Strip one end of the short piece of wire back 1"
(2.54cm) as shown in the following diagram:
2. Double back the piece of bared wire 1/2" (1.27cm) as
shown below.
3. Insert the wire into one end of the fuse holder so that
the insulation is just inside the crimp area as shown
in the diagram. Crimp the wire in place with the
notched portion of a crimping tool.
(2.54cm)
Crimp Here
PROTECTIVE BOOT
11
1.00"
EFX
FUSE HOLDER
red
power