Forest Dental 3900 Operator's Manual

Cleaning Continued
Surfaces
Polished metal surfaces/chrome parts. For ordinary dirt, fingerprints, etc., use a nonabrasive all-purpose cleaner.
Plastic and coated metal surfaces never use abrasive or petroleum based cleaners unless otherwise specified. Spot test all cleaning products on an
unexposed or inconspicuous surface before applying to area you wish to clean.
1. To remove ordinary dirt from plastic and coated metal surfaces:
• Apply a mild soapy solution made from water and household dishwashing liquid with a soft cloth or sponge.
• To remove heavier dirt, apply Formula 409® or Fantastik®.
• Wipe dry immediately with a soft cloth.
2. To remove stubborn stains on plastic parts and surface:
• Apply a mild abrasive such as toothpaste or liquid tooth polish with a soft white cloth.
• Remove all traces of cleanser with a chamois or moist sponge and dry area thoroughly to prevent marking.

Barrier Technique

Forest recommends the barrier technique to protect the finish and appearance of your dental equipment. Disposable
barrier protectors should be used wherever possible to preserve the appearance and life of your equipment.

Chemical Disinfection

CAUTION: Forest does not recommend any chemical disinfectants for all carbon fiber finish and surface cleaning. If you choose to use chemical
disinfectants, we strongly recommend you wipe down the equipment with mild soap and water after use to reduce the harmful effects that chemical
residues leave behind. Daily washing with mild soap and water is recommended. For additional information regarding infection control, we
recommend you contact the American Dental Association or visit their website, www.ada.org

Warranty

Forest warrants its products to be free from defects in material and workmanship only. No other warranties are expressed or implied. This
warranty shall extend for five years unless otherwise stated. Written notice of breach must be given to Forest within this period. Buyer's
remedy for breach of this warranty is limited to repair parts or replacement of items by Forest. Factory repairs are covered for a period of 90 days.
No claim for labor or consequential damages or freight will be allowed. Forest is not responsible for ensuring equipment or installation
conformity to local code or regulatory requirements. Check with local code or regulatory requirements before purchase and installation of all
Forest product. Field modifications that alter the electrical and /or mechanical safety of Forest products conflict with agency construction
file requirements and are not sanctioned by Forest.
Warranty is void if:
Items are carelessly used or improperly maintained or installed. Damage results from using cleaning, disinfecting or sterilization chemicals and
processes. Damage is the result of freight damage and as such claims must be filed with the carrier by dealer. Warranty term exceptions cover
items that are normally expected service items and items not covered by Forest's warranty: Handpiece illumination tubings, heated syringe tubings
& assemblies and light bulbs are warranted for six months. Power supplies, syringe buttons, HVE & SE valves are warranted for one year. Water
bottles, gas springs and handpiece tubings are warranted for two years. Air & Water tubing connectors (T's), Distribution Block, Master Control
Block, Flow Valves, 7000 Chassis are warranted for a maximum of 20 years. Bien-Air handpiece motors, Satelec scaler and Cavitron are covered
under manufacturer's warranty. Two year upholstery warranty, excluding wear and tear. Installation of ancillary devices are warranted for two years.
Forest Dental Products Inc.
Phone 800 . 423 . 3555 Fax 503 . 693 . 9715
 503 . 640 . 3012 |
Authorized Representative: Emergo Europe  prinsessegracht 20 | 2514 ap the hague | the netherlands
Conformity Assessment:
Medical Device Directive Annex VII
Address 6200 ne cherry drive hillsboro oregon 97124
Digital sales@forestdental.com  forestdental.com
|
6.14.17  0097-302  Rev. H
 USA
EC REP
 4 of 4