Key Takeover; Safety Features - Clifford 4811X Owner's Manual

* The factory setting is one press but this can also be programmed for
two presses (See your authorized Directed installer for the amount of
presses programmed).
Record the number of presses to activate remote start here:______

Key Takeover

When you are ready to drive the vehicle:
1. Unlock the doors.
2. Enter the vehicle. Do not step on the foot brake.
3. Insert the key into the ignition and turn it to the run (not start) posi-
tion.
4. Step on the foot brake. The remote start is disabled and the park-
ing lights turn off.
5. Disengage the parking brake and begin driving.
Note If your vehicle uses a Smart Key or PTS (Push-To-Start) system,
please refer to the vehicle specific instructions included with
the owner's guide of the interface module or consult your
authorized dealer.

Safety Features

The following safety features will disable the remote start when acti-
vated or not allow the engine to start if not properly set before starting.
• Foot Brake is depressed
• Hood is open
• Remote Start shutoff switch is OFF
• The pre-programmed run time (12, 24 or 60 minutes) has elapsed
• Remote Start activation procedure is repeated
• Parking brake is disengaged
4
© 2015 Directed. All rights reserved.