Advertisement
Overview
SV Power
Supply
FC Status LED
For XM+ receiver Status
Green LED
ON
Flashing
OFF
Flash Twice
Blue LED For F3EVO Status
Website:www.frsky-rc.com
Instruction Manual for FrSky XMPF3E
V_IN
GND
PWM Output
1~6 Signal
Vbattery
Current
GND
SBUS
+5v
GND
Flash Once
FrSky Electronic Co., Ltd
E-mail:frsky@frsky-rc.com
Micro USB
XM SWD
MicroSD Card Socket
Red LED
Flashing
OFF
Flashing
GND
UART3 Rx
UART3 Tx
+3.3v
Bind Button
Anntenna A
Anntenna B
PWM2 PWM1
PWM4 PWM3
PWM6 PWM5
SCL
SDA
Tx
Rx(UART1)
+5v
+5v
Status
Binding
Normal
Signal lost
Failsafe Set
Technical Support: sales4tech@gmail.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for FrSky XMPF3E
Summary of Contents for FrSky XMPF3E
- Page 1 Instruction Manual for FrSky XMPF3E Overview V_IN SV Power UART3 Rx Supply UART3 Tx +3.3v FC Status LED Bind Button PWM Output 1~6 Signal Vbattery Current Anntenna A SBUS Anntenna B Micro USB XM SWD PWM2 PWM1 PWM4 PWM3 PWM6 PWM5...
- Page 2 The F3EVO runs the open-source Cleanflight/Betaflight flight control (FC) software and firmware upgradeable (SPRACINGF3EVO), the factory firmware is betaflight_3.0.0_SPRACINGF3EVO. The XM+ receiver runs the software which was developed by FrSky and firmware upgradeable. Configuration of F3EVO Because the XM+ receiver receive the commands of Remote Control and send to F3EVO by SBUS(16CH, 8CH is RSSI) to UART2 Rx of F3EVO, we need set the appropriate settings on the Configurator tool.
Need help?
Do you have a question about the XMPF3E and is the answer not in the manual?
Questions and answers