Advertisement
C. Windows might notify you that the driver has not yet passed Windows
Logo testing. Since this product has been tested to work with Windows
XP, click the Continue Anyway button.
C
D. Windows will tell you when it has finished installing the new driver.
Click the Finish button.
D
Configuring the Wireless
PC Card
Important for Windows XP users: Windows XP has
built-in configuration tools. Use the Windows XP Wireless
Zero Configuration, (in the system tray at the bottom of
your screen) to configure the Adapter.
A. After installing the Wireless PC Card the Windows XP Wireless Zero
Configuration icon will appear on your system tray. Double-click the icon
of the two monitors.
A
B. The screen that will appear shows any available wireless network. Select
a Network from the list of Available networks, then click on the Connect
button.
B
C. If your Access Point has enabled WEP encryption, you will see this
screen. Enter the WEP key in the Network Key. Click the Connect but-
ton.
C
In order to find out the WEP encryption set by other wireless products in
your network, such as the WAP54A, run the the setup tab from the web
browser to check the WEP encryption tab for the correct key entries. If
you are using other access points, please check their user guides for more
information on WEP encryption configuration.
D. This screen will appear when your connection is successful.
D
For more information about WEP, refer to the Router's User
Guide or the KnowledgeBase on www.linksys.com.
For further information on Wireless Networking with
Windows XP, search the Windows XP Search Engine using
the keyword: "wireless."
The configuration is complete. For setup
information or any other questions, refer to
the product's User Guide.
QI-WPC54A-032902NC BW
W W W . L I N K S Y S . C O M
Advertisement
