Linux Installation - Code CORTEXJPOS CR6000 User Manual

5.0 - Linux Installation

There are two installers depending on the Java Runtime Environment (JRE) being used: one for 32-bit environments, and one for 64-bit
environments. The "x86" installer should be used if the JRE is the 32-bit runtime environment, and the "x86-64" installer should be used if the
JRE is the 64-bit runtime environment. If using a 64-bit version of the operating system, but a 32-bit version of the JRE, use the "x86" version of
the installer.
The Linux version of the CortexJPOS™ installer is provided as a gzipped tar file. To unzip and install CortexJPOS™, perform the following
commands:
1. Enter the command "tar xzf <INSTALLER_FILENAME>" where
<INSTALLER_FILENAME> is the name of the .tar.gz file that
you received or downloaded.
2. Enter the command "cd <INSTALLER_DIRECTORY>" where
<INSTALLER_DIRECTORY> is the directory that was created by
the previous step, and has the same name as the installer, but
without the ".tar.gz" at the end.
3. Double click on the .exe file (e.g. CortexJPOSSetup-6.0.0-
Linux-x86_64.exe). The screen below will pop up asking if you
wish to continue. Press "Yes".
4. Accept the Terms & Conditions and press Next.
D008733_02 CortexJPOS User Manual
5. On the Welcome screen, press "Next".
6. On the Setup Screen, press "Next".
7. After all the files are installed, click "Next".
6