CRV-S
I
, O
ERIES
NSTALLATION
PERATION AND
SECTION 5: MAJOR COMPONENTS
The figures in this section provide a general overview
of component placement in a CRV-Series system.
The location of some components such as supports
and couplings is crucial for proper installation.
Assemble the heater components as shown on Page
14, Figure 11.
FIGURE 10: Major Component Descriptions
Burner
Reflector
(Aluminum or
Stainless Steel)
Alternate overlap as
shown on overview.
Minimum overlap is 6"
(16 cm).
Flex Gas Line
with shut-off cock
Combustion Chamber
Coupling Assembly
with Lock
8
S
M
ERVICE
ANUAL
45° Elbow
Tee
Tube Adapter
Optional reflector configurations are shown on Page
4, Figure 1 through Page 6, Figure 9. Install
appropriate suspension hardware, beam clamps,
chain or rod at predetermined locations. Adjustments
of chain length will provide uniform pitch.
Tube
Hot rolled, heat treated or
coated aluminized tube
supplied in 10' (3 m) lengths.
Reflector with Hole
(Aluminum or
Stainless Steel)
Alternate overlap as
shown on overview.
Minimum overlap is 6"
(16 cm).
90° Elbow
Cross
End Vent