LG VR6270 series Quick Manual

Quick Guide
Cleaning Robot
This guide briefly describes how to use the Cleaning Robot.
For more detail, please refer to the user manual
s Please read carefully this before installing and operating the product.
VR6260 Ser.
VR6270 Ser.
Power ON and cleaning
1. Turn the Main Power Switch on the rear-left
of main unit.
Be careful not to touch the main button on the unit, when
switching ON the power. Otherwise, the button may
possibly not work.
[Main Power Switch
protection cap]
2. Turn the power ON by pressing the 'Start/
Stop' button on main unit.
Pressing the button may turn ON the display.
www.lg.com
3. Starting and stopping the cleaning
With the Robot Cleaner's power ON, pressing the 'Start/
Stop' button will start the cleaning, and another pressing
will stop it.
After the Robot Cleaner is turned on, press the 'Start'
button on the remote control. A melody will sound and
cleaning will begin.
Press the STOP button during the cleaning cycle to
'Stop' cleaning.
Installation of Home Station
1. Install the Home Station after removing the
protection plastic wrap.
Make sure to install it on a plane spot free of obstacles
within a 1.5 m distance left-right and 2 m distance
forward and not exposed to direct sunlight.
1.5 m 1.5 m
Please, turn the
power switch ON.
2 m
Corner Next to a Couch
Chair
Carpet
Keep the spare cords in order on the power cord hook.
Operation mode and cleaning
1. Operation mode
ZigZag Cell by Cell
▒ ▒
: Swiftly clean a wide : Meticulously clean a
space complex environment
My Space Spot Cleaning
▒ ▒
: Clean a desired, : Intensely clean an area
particular spot
of a 1.5 m diameter
Mi espacio
1.5
m
2. While in use (cleaning/recharging), always
keep the power cord plugged.
Check if the LED glows red
in recharging.
Tip
• If the Charging Terminal has dusts on it, recharging could
fail. Clean regularly the Terminal with a dry mop.
• When putting the Robot Cleaner upside down, make sure to
put it on a soft cloth laid on the floor.
• Before turning over the main unit, remove the Dust Bin, first.
Otherwise, dusts may pour down from the Bin.
2. Starting location
A correct starting point
▒
Power cord connected No obstacles within
to Home Station a 30 cm radius
A wrong starting point
▒
Power cord not connected Start near the wall Start with a hand blinding
to Home Station the sensor lens