Panasonic EB-GD35 Service Manual page 34

Gsm personal cellular phone

Hide thumbs Also See for EB-GD35:

Table of Contents

EB-GD35 EB-GD35C

Channel Box software loaded and the screen indication as follows

PC Screen (SCRN9)

On the PC, select NORMAL MODE and press ENTER.

Press Shift F10 on the PC.

After approximately 1 second, set the ExtPwr switch to ON until the unit powers up.

Entering Call Mode from Test Mode

The screen of the PC should resemble the one shown below:

At the PC, change the SOFT SIM field to read <ENABLE>. Press ENTER.

At the PC, change the TEST MODE field to read <TERM>. Press ENTER.

The UUT will power down and up again. If the UUT is connected to a GSM test set, after a delay of approximately five seconds,

the UUT will register service.

To return to test mode, set the SOFT SIM field to <DISABLE> and set the TEST MODE field to <TEST>. Press Enter.

http://cxema.ru

Figure 6.6: PC Screen (SCRN11)

Table of Contents

Eb-gd35c