Toshiba TCS-NET Service Manual page 22

TCS-NET General Purpose Interface
Analog input/output
Digital output
RO output
Length of stripped signal wires
To connect a wire to a wiring terminal on the signal terminal block, insert a screwdriver or the like into a wiring terminal
opening hole at an angle of 45 degrees and raise the screwdriver end to open the wiring
Insert a wire into the open wiring terminal in this state, and then
terminal opening hole .
Appearance of signal terminal block
9-EN
20 5
CAUTION
Wiring terminal
opening holes
Wiring terminals
Wiring terminal
opening holes
Wiring terminals
– 10 –
U1, U2
Length of stripped TCC-LINK wires
terminal as shown below.
lower the screwdriver end and remove from the
Screwdriver
or the like
Wiring terminal
opening holes
Wiring terminals
Wiring terminal
opening holes
Wiring terminals
Side view of signal terminal block
Installation Manual
10 5
Open the wiring
terminal