Download Print this page
Sirius XM RAdio SXABB2 User Manual
Sirius XM RAdio SXABB2 User Manual

Sirius XM RAdio SXABB2 User Manual

Portable speaker dock
Hide thumbs Also See for SXABB2:

Advertisement

Quick Links

STEP 1:
Identify the Radio Dock Adapter and Radio Connector Module Combination for your Radio
There are four Radio Dock Adapters included with your Portable Speaker Dock, which are
designed to align your particular Radio with the Portable Speaker Dock's connector, and to
provide support for your Radio while it is in the dock. Please note that Radio Dock Adapter XM/
SXM1 is pre-installed in the Portable Speaker Dock.
There are also two Radio Connector Modules included with your Portable Speaker Dock, which
provide the correct connector for your particular Radio. Please note that Radio Connector
Module A is pre-installed in the Portable Speaker Dock.
Both the Radio Dock Adapters and the Radio Connector Modules have a sticker affixed on the
bottom which identifies them. Turn them over to identify them.
The four combinations of the Radio Dock Adapters and Radio Connector Modules are shown
with the Radios each combination supports. Find the correct combination for your Radio, and
note the adapter and module you will use.
Radio Dock Adapter XM/SXM1
(Pre-Installed)
Edge
XpressR
Top View
menu
fm
1
2
3
4
5
6
7
8
9
0
#
jump
Combination 1
XM
SXM1
Onyx EZ, Onyx,
XM/SXM1
=
& Onyx Plus
Xpress
+
Bottom View
Everything is
pre-installed. Skip
menu
ahead to step 3.
FM
jump
1
2
3
4
5
6
7
8
9
0
Radio Connector Module A
direct
XpressRCi & XpressRC
XpressEZ
(Pre-installed)
Top View
Radio Dock Adapter SXM2
Top View
SXM2
SXM2
Combination 2
Lynx
+
Bottom View
=
Follow steps 2A,
2B, and 2C.
Radio Connector Module B
Top View
Radio Dock Adapter XMp3i
Top View
XMp3
XMp3i
XMp3
XMP3
Combination 3
+
=
Bottom View
Follow steps 2A
and 2C. Skip step 2B.
Radio Connector Module A
(Pre-installed)
Top View
Radio Dock Adapter SIRIUS
Sportster 5
Top View
Stratus, & Stratus 4, 5, 6, 7
SIRIUS
SIRIUS
Combination 4
menu
sel
+
Bottom View
=
jump
Follow steps 2A
Starmate 3, 4, 5
and 2C. Skip step 2B.
Radio Connector Module A
(Pre-installed)
Top View
Starmate 8
menu
FM
jump
1
2
3
4
5
6
7
8
9
0
direct
STEP 2:
Install the Radio Connector Module and Radio Dock Adapter
In this step, you will install the Radio Connector Module, if necessary, and Radio Dock Adapter,
according to the combination for your Radio that you determined from the previous step.
Combination 1: Skip this step and go to step 3. The adapter and module are already installed in
the Portable Speaker Dock.
Combination 2: You will remove the pre-installed adapter, remove the pre-installed module,
install Radio Connector Module B, and install Radio Dock Adapter SXM2.
Combination 3 & 4: You will remove the pre-installed adapter, and install the Radio Dock
Adapter for your Radio. Follow steps 2A and 2C, and skip step 2B.
STEP 2A:
Removal of the Radio Dock Adapter
The Radio Dock Adapters are
constructed from precision molded
plastic. During removal, extra care
must be taken to not bend, force, or
volume
aux in
otherwise stress the adapter.
Remove the Radio Dock Adapter
from the Portable Speaker Dock by
placing a coin, or your fingernail, into
the slot at the back of the adapter,
and pulling it up.
STEP 2B:
Removal and Installation of the Radio Connector Module
This step applies only to Combination 2. For all other combinations, skip ahead to step 2C.
a.
Turn the Portable Speaker Dock upside down, and
locate the Radio Connector Module Lock.
b.
While grasping the Portable Speaker Dock as
shown, place a small coin into the center slot on the
lock and turn the lock counterclockwise to unlock
the Radio Connector Module.
c.
Turn the Portable Speaker Dock upright. Place
Coin
a finger in each of the finger recesses in the
Radio Connector Module, grasp, and gently pull
the module straight up and out of the Portable
Radio Connector
Module Lock
Speaker Dock.
Finger Recess
Finger Recess
Radio Connector Module Top View
volume
power
aux in
d.
Insert the Radio Connector
Module B into the dock as
shown.
e.
Keeping your hand on the module to prevent it
from falling out, turn the dock upside down again.
f.
Place the coin into the center slot on the lock
again, and turn the lock clockwise to lock the
Coin
Radio Connector Module into the dock. Turn the
dock upright again.
Radio Connector
Module Lock
STEP 2C:
Installation of the Radio Dock Adapter
The Radio Dock Adapters are constructed from precision molded plastic. During installation, extra
care must be taken to not bend, force, or otherwise stress the adapter.
Place the Radio Dock Adapter for your Radio into the dock. Take care to align the tabs on the
underside of the adapter with the corresponding receptacles on the Portable Speaker Dock, so as
not to bend or break these tabs. Gently press the adapter into the dock until it is seated.
power
volume
aux in
STEP 3:
Install the Batteries or Home Power Adapter
The Portable Speaker Dock can operate on either batteries or by using the Home Power Adapter if you are near
an outlet.
To use your Portable Speaker Dock on-the-go:
To use your Portable Speaker Dock with the Home
Power Adapter:
1
Open the battery compartment on the
1
bottom of the Portable Speaker Dock.
Plug the Home Power Adapter into the
Insert 8 C-cell alkaline batteries in the
connector labeled 14V DC at the rear of
battery compartment.
the Portable Speaker Dock.
2
Plug the other end of the Home Power
Adapter into a standard wall outlet.
2
Replace the battery cover.
antenna
14V DC
TIP! When the battery life is getting low the
power light will blink and your Portable
Speaker Dock may not play.
TIP! It is not recommended to keep batteries
in the Portable Speaker Dock for an
extended length of time. Remove the
batteries when not in use.
STEP 4:
Install the Indoor/Outdoor Home Antenna
1
Plug the antenna cable into the
antenna connector at the left rear.
2
Wrap the antenna cable into the
storage area.
3
Place the antenna into the storage
area at the rear of the Portable
Speaker Dock. Align the mounting
holes on the bottom of the antenna
with the 4 mounting brackets on
the rear of the Portable Speaker
Dock. Push the antenna over the
mounting brackets and then slide
the antenna down slightly to secure
it in place.
TIP! If you are using the Portable Speaker Dock
4
Open the antenna clamshell so that
indoors, consult the User Manual beginning on page
the top of the antenna is facing the
30 for instructions for indoor antenna placement.
sky.
Continued on the other side

Advertisement

loading
Need help?

Need help?

Do you have a question about the SXABB2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sirius XM RAdio SXABB2

  • Page 1 STEP 1: Identify the Radio Dock Adapter and Radio Connector Module Combination for your Radio STEP 2: Install the Radio Connector Module and Radio Dock Adapter STEP 3: Install the Batteries or Home Power Adapter There are four Radio Dock Adapters included with your Portable Speaker Dock, which are In this step, you will install the Radio Connector Module, if necessary, and Radio Dock Adapter, The Portable Speaker Dock can operate on either batteries or by using the Home Power Adapter if you are near designed to align your particular Radio with the Portable Speaker Dock’s connector, and to...
  • Page 2 Locks and unlocks the Radio Connector Module. jump bank Headphones © 2013 Sirius XM Radio Inc. Sirius, XM and all related marks and logos are trademarks of Sirius XM Radio Inc. Connection for PULL headphones. SXABB2 Portable Speaker Dock QSG 131022a...