Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dynamite DYN4064
Summary of Contents for Dynamite DYN4064
- Page 1 PassPort Ultra aC/DC Charger CyCler oPeration ManUal www.DynaMiterC.CoM...
-
Page 2: Table Of Contents
Contents introduction Introduction ............2 Thank you for purchasing the Dynamite ® Passport Ultra AC/DC Peak Detection ™ Specifications ............2 Charger/Cycler. The Passport line of chargers Features ..............3 are high performance battery management Available Charge Cords and Adapters ....3 chargers that can improve the reliability and life of most battery packs. -
Page 3: Features
• 4-in-1, 16-bit microchip CPU controller. The Passport Ultra includes the Deans Ultra • Built-in system temperature protection with style charge cord (DYN5006). Dynamite offers additional battery temperature sensor for charge cords and adapters for all your battery added safety. charging requirements. See the list below to • Convenient AC or DC input low voltage 10-... -
Page 4: Available Balance Adapters
Balance adapters DYN5005 You may also purchase adapters to adapt Charge Adapt Banana to Tamiya Male Thunder Power and Losi balance plugs to fit the Dynamite balance charge sockets. DYN5012 Adapter Cables-THP BAT-DYN Balancer, 2–6S DYN5011 Adapter Cables-LOS BAT-DYN Balancer, 2–6S... -
Page 5: Input Power Connection
STOP to clear settings. D. A completely discharged Li-Po or Li-Fe battery pack can be fully recharged in D. Press and hold the START button for 3 approximately 2–3 hours with charge rate at seconds to charge/discharge. Dynamite Ultra AC/DC Charger/Cycler www.DynamiteRC.com... -
Page 6: User Setup Menu
Ni-MH negative delta 9900 mAh voltage cutoff/cell. 9. Adjust Max Charge Capacity Nicd Sensitivity D.Peak 5mV/Cell 4. Adjust Ni-Cd Charge Sensitivity The Ni-Cd Sensitivity option allows adjustment of the Ni-Cd negative delta voltage cutoff/cell. www.DynamiteRC.com Dynamite Ultra AC/DC Charger/Cycler... -
Page 7: Ni-Mh And Ni-Cd Charge Mode
Load Default 1. Ni-MH Charge Sensitivity YES/NO ? To reset to factory recommended sensitivity, see Load Default and select “Yes.” 14. To reset the charger to Initial Setting Peak Voltage 9.07V 2. Battery Pack Peak Voltage Dynamite Ultra AC/DC Charger/Cycler www.DynamiteRC.com... -
Page 8: Ni-Mh Discharge Mode
Cycle Charge Press the mode button once Ni-MH is selected Delay 1min and rotate the dial until the Discharging screen appears. Press the dial to select discharge current rate and cutoff voltage. 8. Charge/Discharge Delay Time www.DynamiteRC.com Dynamite Ultra AC/DC Charger/Cycler... -
Page 9: Ni-Mh Discharge/Charge Cycle Mode
The screen above shows discharge then charge status. Batt Temp Cutoff NiMH 000 : 01 : 0001 50°C C>D 0.10A 7.84V 3. Max Discharge Temperature This screen is displayed during the charge then discharge mode. Dynamite Ultra AC/DC Charger/Cycler www.DynamiteRC.com... -
Page 10: Li-Ion, Li-Po And Li-Fe Charge Mode
To select the correct voltage, use the following formula to calculate the voltage of your pack: 3.7V/cell (e.g. 4S = 4*3.7=14.8V). Be careful to confirm the correct voltage and cell count. Failure to due so may result in damage or fire. www.DynamiteRC.com Dynamite Ultra AC/DC Charger/Cycler... - Page 11 2. Which Battery has the High/Low Voltage The second battery has the High voltage. The third battery has the Low voltage. Unbalanced Volt 12mV 3. Unbalanced Voltage The voltage difference between the high voltage and low voltage cells in the pack. Dynamite Ultra AC/DC Charger/Cycler www.DynamiteRC.com...
-
Page 12: Li-Ion/Poly Balance Charge Mode
NOTE: The second battery has the high voltage. The third battery has the low voltage Unbalanced Volt 3. Unbalance Voltage The voltage difference between the high voltage and low voltage cells in the battery pack. www.DynamiteRC.com Dynamite Ultra AC/DC Charger/Cycler... -
Page 13: Li-Ion/Poly Discharge Mode
System Temp 36°C 4. Battery voltage is over 4.26V per cell. 2. DC Input Voltage/System Temperature See previous step. The charger will drop to a low current rate until the cells are balanced within specifications. Dynamite Ultra AC/DC Charger/Cycler www.DynamiteRC.com... -
Page 14: Pb Charge Mode
Pb 000:01 0001 charging and is not adjustable once charging has DIS 1.00A 11.96V begun. Input 13.01V See the status by turning the dial during the charging process. System Temp 36°C 2. Input Voltage/System Temperature www.DynamiteRC.com Dynamite Ultra AC/DC Charger/Cycler... -
Page 15: Warning Information
10. Li-Po/Li-Fe Battery Low Voltage, LOW/VOL will flash alternately. 11. Cooling fan is not working, FAN/STOP will flash alternately. System Err Return to Repair 12. Charger Breakdown Current Err Return to Repair 13. Charger Breakdown Dynamite Ultra AC/DC Charger/Cycler www.DynamiteRC.com... -
Page 16: Safety Precautions
Product. This warranty does not cover damage due to improper installation, operation, maintenance, or attempted repair by anyone other than Horizon. Return of any goods by Purchaser must be approved in writing by Horizon before shipment. www.DynamiteRC.com Dynamite Ultra AC/DC Charger/Cycler... -
Page 17: Damage Limits
Provided warranty conditions have been met, your Product will be repaired or replaced free of charge. Repair or replacement decisions are at the sole discretion of Horizon Hobby. Dynamite Ultra AC/DC Charger/Cycler www.DynamiteRC.com... -
Page 18: Non-Warranty Repairs
Horizon Hobby UK Units 1-4 Ployters Rd Staple Tye Harlow, Essex CM18 7NS United Kingdom Please call +44 (0) 1279 641 097 or e-mail us at sales@horizonhobby.co.uk with any questions or concerns regarding this product or warranty. www.DynamiteRC.com Dynamite Ultra AC/DC Charger/Cycler... -
Page 19: Ce Compliance Information For The European Union
Horizon Hobby, Inc. waste disposal service or where you purchased Champaign, IL USA the product. May 21, 2009 Steven A. Hall Vice President International Operations and Risk Management Horizon Hobby, Inc. Dynamite Ultra AC/DC Charger/Cycler www.DynamiteRC.com... - Page 20 Distributed exclusively by Horizon Hobby, Inc. 4105 Fieldstone Road Champaign, Illinois 61822 (877) 504-0233 www.horizonhobby.com ©2009 Horizon Hobby, Inc. 15245 Printed 08/2009...
Need help?
Do you have a question about the DYN4064 and is the answer not in the manual?
Questions and answers