Bellman & Symfon VISIT BE1551 User Manual

VISIT TRANSMITTERS
Visit smoke alarm
Overview
Signal horn Test button
Front cover 2 x screw holes

Technical specifications

In the box Size and weight
BE1551 Visit smoke alarm Height: 118 mm, 4.6"
 
1 x 9 V alkaline battery Width: 140 mm, 5.5"
 
 2 x screws and plugs  Depth: 42 mm, 1.6"
User manual Weight: 200 g, 7 oz. incl. battery
 
Power and battery Sensor type
Battery type Ionization smoke detection
 
Duracell MN1604
9 V alkaline battery
Audible alarm
Power consumption

Min 85 dB(A) @ 3m (10'), 2.6 kHz

Idle position < 15 μA
Activation
Battery life

Minimum 3 years
Via the test button

Via the built-in smoke detector

1
Radio LED
Battery Radio button Status LED
Frequency and coverage
Radio frequency

868.30 MHz
Coverage: Up to 200 m (218 yd.), clear

line of sight. It depends on the building's
characteristics and radio conditions.
Environment
For indoor use only

Operating temperature

4° till 40° C, 39° to 104° F
Relative humidity

15% to 95% RH, non-condensing
Smoke sensitivity
Meets the BS EN 14604:2005 standard

Setting up the smoke alarm
1
Remove the front cover by rotating it fully backwards and connect the battery to the battery snaps to start the unit.
The alarm will chirp during startup.
2 Mark the location of the screw holes and fix the smoke alarm to the ceiling using the supplied screws and plugs. Mount
it at least 30 cm, (12") from walls and other obstructions, see Location and positioning below.
3 Put the cover back on the smoke alarm by pressing gently until it snaps into place.
1
Location and positioning
Sensor
Fit the smoke alarms in the center of the ceiling outside
the bedrooms, at least 30 cm from any wall. If the
bedrooms are in different areas of the house, separate
smoke alarms are recommended. In multi-storey
properties, install at least one smoke alarm on each floor.
Avoid kitchens, fireplaces or garages, as cooking
fumes and car exhaust may cause false alarms. The
smoke alarm should not be installed in damp spaces,
close to fans, etc. or in agricultural buildings.
= Minimum

= Additional

BE1551
2 3
Testing the connection
1
Press and hold the smoke alarm test button until the alarm
sounds. The smoke alarm transmits a radio signal to the
receiver.
2 The red Visit LED on the receiver lights up to show that the
signal was received. In addition, it starts to sound, flash or
vibrate depending on the receiver.
Please note: The smoke alarm will stop sounding shortly after
the button is released and the receiver will time out within 40s.
1 2
2