MINN KOTA CE Master User Manual
  1. Manuals
  2. Brands
  3. MINN KOTA Manuals
  4. Outboard Motor
  5. CE Master
  6. User manual
MINN KOTA CE Master User Manual

MINN KOTA CE Master User Manual

E-drive primary propulsion motor
Hide thumbs Also See for CE Master:
Table of Contents

Advertisement

Quick Links

Download this manual
CE Master User Manual for
PRIMARY PROPULSION MOTOR
MOTEUR DE PROPULSION PRIMAIRE
NOTE: Do not return your Minn Kota motor to your retailer. Your
retailer is not authorized to repair or replace this unit. You may
obtain service by:
• calling Minn Kota at 1-800-227-6433 or 1-507-345-4623;
• returning your motor to the Minn Kota Factory Service Center;
• sending or taking your motor to any Minn Kota authorized ser-
vice center on enclosed list.
Please include proof of purchase, serial number and purchase
date for warranty service with any of the above options.
REMARQUE: Ne pas retourner le moteur Minn Kota au
concessionnaire. Ce dernier n'est pas autorisé à le réparer ou à le
remplacer. En cas de panne:
• Contacter Minn Kota au 1-800-227-6433 ou au
1-507-345-4623;
• Retourner le moteur à l'usine Minn Kota;
• Ou à un centre de Minn Kota agréé de la liste suivante.
Quelle que soit l'option, joindre la facture, mentionner le n° de
série et la date d'achat pour bénéficier de la garantie.

serial number

numéro de série
purchase date
'
date d
achat
PLEASE THOROUGHLY READ THIS USER
MANUAL. FOLLOW ALL INSTRUCTIONS AND HEED
ALL SAFETY & CAUTIONARY NOTICES BELOW.
USE OF THIS MOTOR IS ONLY PERMITTED FOR
PERSONS THAT HAVE READ AND UNDERSTOOD
THESE USER INSTRUCTIONS. MINORS MAY USE
THIS MOTOR ONLY UNDER ADULT SUPERVISION.
LISEZ S'IL VOUS PLAÎT TOUT À FAIT CE MAN-
UEL D'UTILISATEUR. SUIVEZ TOUTES LES INSTRUC-
TIONS ET FAITES ATTENTION À TOUTE LA SÉCURITÉ
ET AUX PRÉAVIS D'AVERTISSEMENT CI-DESSOUS.
L'UTILISATION DE CE MOTEUR EST SEULEMENT
PERMISE POUR LES PERSONNES QUI ONT LU ET
ONT COMPRIS CES INSTRUCTIONS D'UTILISATEUR.
LES MINEURS PEUVENT UTILISER CE MOTEUR
SEULEMENT DANS LA SUPERVISION ADULTE.
Feature Information
Renseignements sur les particularités
Controller Features
Mounting
Cautions
Battery Information
Circuit Breaker
Wiring Diagram
Testing and Operation
Particularités sur l'assemblage détachable
Break Away Features
Transporting
Maintenance
Prop Replacement
Troubleshooting
Warranty
E-DRIVE
Particularités de la commande
Montage
Prudences
Information sur les batteries
Disjoncteur
Schéma de Câblage
Essais et fonctionnement
Transport
Entretien
Remplacement de l'hélice
Dépannage
Garantie
pg. 2
pg. 3-4
pg. 5-10
pg. 11
pg. 12
pg. 13
pg. 14
pg. 15-16
pg. 17
pg. 18
pg. 19
pg. 19
pg. 20
pg. 21

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CE Master and is the answer not in the manual?

Questions and answers

Related Manuals for MINN KOTA CE Master

Summary of Contents for MINN KOTA CE Master

  • Page 1: Serial Number

    1-507-345-4623; • Retourner le moteur à l’usine Minn Kota; • Ou à un centre de Minn Kota agréé de la liste suivante. Quelle que soit l’option, joindre la facture, mentionner le n° de série et la date d’achat pour bénéficier de la garantie.
  • Page 2 Direction Indicator Indicateur de direction Maximizer / Permanently Sealed Electronics Maximizer / circuits Cable Steer Compatible électroniques scellés en Compatible à la direction permanence par câble Bolt On Transom Bracket Support de tableau arrière boulonné Built in break away Assemblage détachable incorporé...
  • Page 3 LCD Display Affichage à cristaux liquides Tilt Up/Down Switch Interrupteur de relevage/abaissement Master Key Switch Interrupteur à Throttle Control clé principal Lever Levier de commande de l’accélération Percentage of Power Voltage Fuel Gauge LCD Display Pourcentage de puissance Battery Fuel Gauge Indicateur THROTTLE FAULT d’énergie des...

  • Page 4: Controller Features

    CONTROLLER FEATURES: • Throttle Control Lever: Has Forward / Neutral / and Reverse positions. • Tilt up / down Switch: Allows the motor to be tilted up or down. • Master on/off key Switch: Turns system on and off. • LCD Display: Displays the following features: •...

  • Page 5: Tools Required

    COMPONENTS: Throttle Assembly w/Cable Drag Link E-Drive Motor Motor / Throttle Mounting Templates (two copies are included: Owner’s Manual and Throttle Assembly.) Throttle Assembly Mounting Hardware Trim Gauge w/Mounting Hardware OPTIONAL E Drive Motor Mounting Hardware Jumper wire-1’ (2) Jumper wire-4’ (1) Propeller assembly TOOLS REQUIRED: 1/8”...
  • Page 6 NOTE: MINN KOTA MOTORS/JOHNSON OUTDOORS IS NOT RESPONSIBLE FOR ANY DAM- AGE DUE TO IMPROPER RIGGING OR INSTALLATION OF THE E-DRIVE UNIT. Mounting the E-Drive unit: The Motor Mounting Template is printed in two locations. One copy is printed in the Owner’s Manual and a second copy is packaged with the Throttle Assembly.
  • Page 7 THROTTLE ASSEMBLY INSTALLATION: CAUTION: WHEN INSTALLING THE THROTTLE ASSEMBLY MAKE SURE THE MOUNTING AREA IS CLEAR OF ANY OBSTRUCTIONS ON THE UNDERSIDE OF THE MOUNTING SURFACE, AND CLEAR OF THE STEERING WHEEL, SWIVELING SEATS, ETC. SURFACE/BINNACLE THROTTLE MOUNTING: The Throttle Assembly Mounting Template is also printed in two locations. One copy is printed in the Owner’s Manual and a second copy is packaged with the Throttle Assembly.
  • Page 8 SIDE MOUNTING THROTTLE: A Side Mount Bracket is included with the Throttle Assembly. 1). Place the Side Mount Bracket in the area you wish to mount the Throttle Assembly and check for any obstructions. Reposition if necessary. Mark the four mounting hole locations. 2).
  • Page 9 1).The tilt sending unit included with the Minn Kota E-Drive electric outboard motor is equipped with a 2 conductor lead, 20 ft in length. This 2 conductor leads provides the tilt gauge signal.
  • Page 10 Otherwise, connect this wire to the +12 volt positive battery post, of battery #1 of the 4-12 volt bat- teries that are series con nected to provide power for the Minn Kota E-Drive electric outboard. 8). For internal gauge backlighting, connect a wire from the 1/4” blade terminal to the +12 volt switched accessory circuit of the watercraft, if the watercraft is so equipped.
  • Page 11 Attention: •Avoid running your motor with the propeller outside of the water. This may result in injuries from the rotat- ing propeller. •It is recommended to set the speed selector to zero and place the motor in the deployed position prior to connecting power cables.

  • Page 12: Battery Information

    Maintenez la charge totale des batteries. Omettre de recharg- er les batteries à acide de plomb (dans les 12 à 24 heures) est la cause principale de panne prématurée de batterie. Pour de meilleurs résultats, utilisez un chargeur à taux variable de Minn Kota pour éviter de surcharger.
  • Page 13 101# 36V 50A @ 36VDC E-Drive 48V 40A @ 48VDC Le calibre approprié devait raccorder votre Minn Kota le moteur au moteur batteries varie selon la longueur de câble nécessaire et de voltage du moteur. Pour les renseignements supplémentaires, consultez s’il vous plaît ABYC approprié...
  • Page 14 Contactor 48 VOLT WIRING Relais de contact CÂBLAGE DE 48 V Resistor Résistance Rear terminal Cosse arrière Orange tail Orange pontage Front post Rear post Black actuator lead Borne avant Borne arrière Fil noir du vérin Front terminal Red Motor (+) Cosse avant Rouge (+) du moteur...

  • Page 15: Operation

    Light Assembly Assemblage d’éclairage Blade Terminal (+) to instru- ment lighting circuit. Cosse à lame (+) pour le circuit d’éclairage de l’in- strument Ignition Terminal (+12v) on ignition switch Cosse d’allumage (+12 V) sur l’interrupteur d’allumage 2-1/16” dia. hole Trou de 52,39 mm (2-1/16 po) de diamètre Black wire (-12v, ground)
  • Page 16 ESSAIS : Quand le raccordement et le montage seront terminés, le moteur devra être essayé pour vous assurer que tout fonctionne correctement. Suivez ces étapes : 1). Assurez-vous que tous les objets et personnes soient éloignés de l’hélice. 2). Placez l’interrupteur maître en position de marche et confirmez visuellement que l’affichage à cristaux liquides soit allumé.
  • Page 17 BREAK AWAY FEATURES: The E-Drive electric outbaord features a built-in break away system. If, while moving forward, the E-Drive motor lower unit contacts an underwater obstruction, the break away system will release and allow the the motor unit to swing up and over the obstruction preventing damage to the E-Drive motor shaft, lower unit, and propeller.
  • Page 18 TRANSPORTING THE E-DRIVEUNIT: CAUTION: TILT LOCK ARM MUST BE USED IF BOAT IS TRAILERED WITH MOTOR RAISED. FAILURE TO USE TILT LOCK WILL DAMAGE LIFT ACTUATOR AND VOID WARRANTY. CAUTION: IF TOWING THE BOAT ON THE WATER BECOMES NECESSARY, MAKE SURE MOTOR IS TRIMMED OUT OF THE WATER OR TOWED AT LESS THAN 5MPH.

  • Page 19: Maintenance

    MAINTENANCE: 1 After use, rinse the unit with fresh water and allow to dry. Then, wipe it down with a cloth dampened with an aqueous based silicone spray. The E-Drive series is not intended for salt water use. Use in salt water will void your warranty.

  • Page 20: Troubleshooting

    • Voyez si l’eau est peu profonde ou s’il y a des obstructions sous-marines. 6) Le moteur tourne, mais l’hélice ne tourne pas. • Examinez la goupille de cisaillement, remplacez-la si elle est cassée. REMARQUE : Pour toutes autres défaillances, prenez contact avec un centre de réparation MINN KOTA agréé.

  • Page 21: Limited Two-Year Warranty

    1-800-227-6433, 1-507-345-4623 or fax 1-800-527-4464. Note: Do not return your Minn Kota® motor or parts to your retailer. Your retailer is not authorized to repair or replace them. Terms Applicable to Both Warranties...

  • Page 22: Repair And Troubleshooting

    AUTHORIZED SERVICE CENTERS Minn Kota has over 300 authorized service centers in the United States and Canada where you can purchase parts or get your products repaired. Please visit www.minnkotamotors.com and click on “Service Center Locator” under the “Service” tab to locate a service center in your area.
  • Page 23 E-Drive This page provides MinnKota® WEEE compliance disassembly instructions. For more information about where you should dispose of your waste equipment Remote Steer for recycling and recovery and/or your European Union member state require- ments, please contact your dealer or distributor from which your product was Moteur E-Drive purchased.
  • Page 24 In the U.S.A., replacement parts may be ordered directly from MINN KOTA Parts Dept., 121 Power Drive,P.O. Box 8129 Mankato, Minnesota 56002- 8129. In Canada, parts may be ordered from any of the Canadian Authorized Service Centers shown on the enclosed list. Be sure to provide the Aux É.-U., les pièces de rechange peuvent être commandées directement du département MINN KOTA Parts Dept., 121 Power Drive, P.O.
  • Page 25 Please use the correct part numbers from the parts list. Payment for any parts ordered model serial from the MINN KOTA parts department, may be by cash, personal check, Discover Card, MasterCard or VISA. To order, call 1-800-227-6433 or FAX 1-800-527-4464. vous de fournir les numéros de de votre moteur quand vous commandez des pièces.

  • Page 26: Environmental Compliance Statement

    Minn Kota motors are not subject to the disposal regulations EAG-VO (electric devices directive) that implements the WEEE directive. Nevertheless never dispose of your Minn Kota motor in a garbage bin but at the proper place of collection of your local town council.
  • Page 27 Minn Kota accessories available for your motor. Circuit Breakers OnBoard Chargers Battery Monitors Charger Extension Cables AC Power Port Visit our website at www.minnkotamotors.com © 2010 Johnson Outdoors Marine Electronics, Inc. P/N 2047102 REV. R ECN 32281 6-10...

Table of Contents