LXNAV CAN Remote Installation Manual Version 1.1 April 2018 Important Notices Limited Warranty Technical Data Versions Functionality Diameter of command handles Shapes Installation Functions Remote without SC cable Revision history 2 of 9 Page...
LXNAV retains the exclusive right to repair or replace the unit or software, or to offer a full refund of the purchase price, at its sole discretion. SUCH REMEDY SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY FOR ANY BREACH OF WARRANTY.
LXNAV CAN Remote Installation Manual Version 1.1 April 2018 2 Technical Data • Power input 8-18V DC • Consumption at 12 V: 60mA • Weight 300g 4 of 9 Page...
LXNAV CAN Remote Installation Manual Version 1.1 April 2018 3 Versions 3.1 Functionality Standard version Shempp-Hirth version with EB28 version with trim red starter button for M switch gliders 3.2 Diameter of command handles Diameter Gliders 19,3mm DG, LAK, Shempp-Hirth...
LXNAV CAN Remote Installation Manual Version 1.1 April 2018 4 Installation LXNAV remote stick is connected to CAN bus through Remote-Can adapter. Be careful, that connect correct colour wire to pin, which is marked with same colour. PTT wires are connected to radio, SC is connected to Speed to fly input of vario unit.
We have been working very hard to simplify the remote stick so that we can have the same functionality but use fewer cables. The LXNAV new remote stick comes without the standard SC cable but the functionality is still available.
Need help?
Do you have a question about the CAN remote and is the answer not in the manual?
Questions and answers