Baofeng UV-B5 Programming Manual

Baofeng UV-B5 Step-by-Step Programming Guide
Also applies to UV-B6

Set the radio to communicate with a repeater at 147.080+ MHz, 77.0 Hz

0. Turn on the radio and make sure it's unlocked
1. VM /SCAN (frequency mode)
2. Select the upper display
AB
3. Set the frequency
1 - 4 - 7 - 0 - 8 - 0
4. Turn off the TDR
M ENU - (10) - AB

Store the current repeater and tone settings in a memory channel

0. Follow the procedure above to set your radio
for the frequency of your choice
1. Store the frequency in channel 57
Press and hold VM /SCAN
(57) - AB
(Note: if the channel number is blinking, there
is already a frequency stored there, and this
w ill overw rite it)
The frequency is now stored in radio memory

Recall a stored memory setting

1. Press VFO/M R (channel mode)
2. Press the up or dow n arrows or enter the
tw o-digit channel number (both digits)
0 - 6
The stored channel is now ready for use
- OFF - AB - M ENU
5. Set the repeater offset
M ENU - (22) - AB
6. Set the repeater shift direction
M ENU - (21) - AB
7. Set the transm it tone frequency
M ENU - (12) - AB
- M ENU
8. Set the transm it pow er level
M ENU - (04) - AB
Your radio is now set to transm it as specified
Noji Ratzlaff
- 00600 - AB - M ENU
- + - AB - M ENU
- M ENU - (77.0) - AB
- HIGH - AB - M ENU