Advertisement
1. P
T
OWER ON
ERMINAL
There are two holes under a plastic cover on the
right side of terminal (Figure 1).
One is power input, another is a port for devices
connected to terminal (Figure 2). (Adapter Input:
100-240V, 50/60Hz 1A; Output: 12V, 3.33A)
Rechargeable battery is on the back side of terminal
(Figure 3). (Lithium ion battery pack: 7.4V, 2.2A)
After plugged power cord or installed the battery,
press the power button on the front to power on it
(Figure 4).
Caution: Risk of explosion if the battery is replaced
by an incorrect type. Please dispose of used battery
according to the instructions.
Environment:
Operating Temperature: 0°C to 40°C
Storage Temperature: - 20°C to 60°C
2. L
P
OADING THE
APER
Pop the printer cover's latch to open the cover
(Figure 5); then lift the cover.
Load a roll of paper (Appleton 1012 recommended)
into the printer (Figure 6). The print-side of the
paper will feed out facing the operator.
Close the cover and tear off any excess paper
(Figure 7).
The printer is now ready to use.
Caution: For body worn operation, this terminal
will keep away 20cm from the body in order to
meet the FCC RF exposure guidelines
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
3. U
C
R
SING THE
ARD
Find the reader slot in the middle of surface. Swipe
card through slot in left to right or the opposite
direction with stripe face to us (Figure 8).
Find the reader slot on the bottom. Insert smart card
into slot with IC chip to face up (Figure 9).
4. U
K
P
SING THE
EY
AD
The keypad allows you to select transaction types
and enter information. Its 16 keys can be used to
select numbers, letters, and to enter data (Figure 10).
To enter numbers or letters, simply press the
appropriate key. For example, to type the letter A,
press [ALPHA], then [A] (the Void key) (Figure 11)
EADER
Figure 8
Figure 9
Figure 10
Figure 11
Advertisement
