RIDGID SP6263 Owner's Manual page 67

Cutting Problem
Inaccurate cut
Crosscuts not accurate at
indexed miter positions
Depth of crosscut varies from
one side of workpiece to other
Saw cuts at slight bevel
Workpiece kerf rough with
tooth marks from blade
Blade tends to advance
through workpiece too fast
during crosscutting
Possible Cause(s)
Loose locks
Saw out of alignment
Sawdust between workpiece
and fence
Fence not straight
Swivel lock loose or not
locked
Crosscut travel not square
with fence
Carriage assembly loose on
arm
Arm not indexing properly
Looseness between column
tube and column support
Table not parallel with radial
arm
Blade not square to table
Table not parallel to radial arm
Bevel lock loose
Work table not flat
Carriage bearings loose
Blade not square to fence
Using improper blade for
desired finish cut
Blade dull
User pulls blade through
workpiece too fast
Incorrect blade
Troubleshooting
What to Do
Check miter, rip, bevel, and
swivel locks. See Adjustments
section
Check alignment
Keep front table clean
Replace fence
Adjust swivel lock for wear
Square blade crosscut travel
Adjust carriage bearings, then
realign saw
Adjust miter lock for wear
Adjust column support
Adjust table supports
Square blade to table for
crosscutting and ripping
Adjust table supports
Adjust bevel lock
Adjust or replace table
Adjust carriage bearings, then
realign saw
Square blade to fence
Use proper smooth-cutting
blade
Sharpen or replace blade
Pull blade slowly and steadily
through workpiece
Replace blade with one
designed for radial arm saws.
67