RIDGID BS14002 Operator's Manual page 18

ASSEMBLY
MOUNTING BLADE HANGERS
See Figure 18.
n Locate the following items.
4 pan head screws, (M4 x 0.7-10)
4 hex nuts, (M4 x 0.7)
4 lock washers, (M4)
2 blade hangers
1 pulley cover
n Align blade hangers over the holes on opposite sides of
the pulley cover. Make sure they are pointing in opposite
directions. Fasten blade hangers using pan head screws,
lock washers, and hex nuts, as shown.
MOUNTING THE PULLEY COVER
See Figure 19.
n Locate the following items.
3 pan head screws, (M5 x 0.8-12)
6 washers, (M5)
3 hex nuts, (M5)
n Place pulley cover over both pulleys. Align holes in the
pulley cover to holes in the leg stand. Fasten pulley cover
to leg stand using pan head screws, washers, and hex
nuts, as shown.
PULLEY COVER
HEX NUTS
LOCK WASHERS
WASHER
18
BLADE
HANGERS
PAN HEAD
SCREWS
Fig. 18
PAN HEAD
SCREWS
HEX NUTS
Fig. 19