Step#17
Install foam strip to strike edge of tube opening
so that door seal closes against it.
Step#19
Adjusting Spring Plunger. 3-Ways to do so.
1) Adjust plunger depth (In-Out)
2) Adjust mounting block location (Left-Right)
3) Adjust plunger spring tension (Rear Set Screw)
Note: Grease the Pin end of Plunger and the steel
roller pressed in the aluminum Door Ring with
grease supplied in kit.
Step#18
Test door operation. Door should stay sealed tight
when carrier arrives in teller. If the door seal leaks
on the strike side, you can adjust the position of the
Detent Mounting Block to the right.
Step#20
Re-install Upper and Lower Switch covers.
Note: Use 10-32 x ¼ HHMS provided in kit
to mount lower switch cover.
6
39
5
4
K