Advertisement
Quick Links
Model
Step #
6
10-32 x 1/4" Thick Spacer Nuts
7
Upper Door Ring (Aluminum)
8
Door Bearing (Black Plastic)
15
Detent Mounting Block
15
Spring Plunger Detent (Installed in Mounting Block)
15
10-32 x 3/8 Set Screw (Installed in Mounting Block)
15
3/32" Allen Wrench
15
Grease, Mini tube Lithium
17
Foam Strip Seal (1/4" x 9-3/4") P/N B6620
20
10-32 x 1/4" HHMS
Note: Please retain all parts removed from unit and return using supplied UPS label.
HA-1000/HA45
Overhead Teller Upgrade Kit
B6672
Installation Instructions
Parts List
Description
1
Quantity
3
1
2
1
1
1
1
1
1
2
Advertisement
Related Manuals for Hamilton HA-1000
Summary of Contents for Hamilton HA-1000
- Page 1 HA-1000/HA45 Model Overhead Teller Upgrade Kit B6672 Installation Instructions Parts List Step # Description Quantity 10-32 x 1/4" Thick Spacer Nuts Upper Door Ring (Aluminum) Door Bearing (Black Plastic) Detent Mounting Block Spring Plunger Detent (Installed in Mounting Block) 10-32 x 3/8 Set Screw (Installed in Mounting Block) 3/32"...
- Page 2 Step#1 Step#2 Remove Carrier Bumper and Check Valve Gasket Remove Exhaust Chamber Cover. Note: Cover is sealed with silicone from factory. Only needs re-sealed if used in Point-to-Point. Step#3 Step#4 Remove 3 Coupler Nuts holding lower frame. Remove Door Assembly including ALL rings. Remove Lower Frame and spacer nuts.
- Page 3 Step#5 Step#6 Remove ALL silicone from tube frame. See Arrow. Mount NEW spacer nuts to bottom plate using Note: This must be cleaned so that top Door Bearing existing screws. rest flat under top plate. Step#7 Step#8 Replace Upper Door Ring with part in kit. Replace upper and lower Door Bearings with New ring has cylinder retained by screw for detent.
- Page 4 Step#9 Step#10 Replace Door Assembly with ALL rings Replace Lower Frame using existing coupler nuts. stacked as shown in step#7. Step#11 Step#12 Check rotation and vertical play of door. Re-install Exhaust Chamber Cover. Shim washers may need to be added to spacers Note: Cover is sealed with silicone from factory.
- Page 5 Step#13 Step#14 Re-install Carrier Bumper and Check Valve Gasket Remove Upper and Lower Switch covers. Step#15 Step#16 Remove Detent Mounting Block and Ball Nose Adjust Detent Mounting Block to the extreme Spring Plunger. Replace with New Block and Left of its mounting slot. Adjust Spring Plunger New Spring Plunger supplied in kit.
- Page 6 Step#17 Step#18 Install foam strip to strike edge of tube opening Test door operation. Door should stay sealed tight so that door seal closes against it. when carrier arrives in teller. If the door seal leaks on the strike side, you can adjust the position of the Detent Mounting Block to the right.