Hamilton HA-1000 Installation Instructions Manual page 5

7
13
Step#13
Re-install Carrier Bumper and Check Valve Gasket
Step#15
Remove Detent Mounting Block and Ball Nose
Spring Plunger. Replace with New Block and
New Spring Plunger supplied in kit.
Grease the Pin end of Plunger and the steel
roller pressed in the aluminum Door Ring
with grease supplied in kit.
42
29
23
28
K
5
Step#14
Remove Upper and Lower Switch covers.
Step#16
Adjust Detent Mounting Block to the extreme
Left of its mounting slot. Adjust Spring Plunger
So that it does not contact aluminum door ring,
only the steel roller pressed in the door ring.
39
5
4
42