Guide To Parts And Controls; Remote - Sony HT-IV300 Operating Instructions Manual

Guide to Parts and Controls

For more information, refer to the pages indicated in parentheses.
Front panel
A "/1 (on/standby)
Turns on the main unit, or sets it to
standby mode.
B
(N-Mark) (page 38)
Position the NFC-compatible device
near this indication to activate the NFC
function.
C Front panel display
D Soft-touch buttons
Notes
• These buttons work when you touch them
lightly. Do not press on them with
excessive force.
• If the button does not work, release the
button and wait for a few seconds. Then,
touch the button again with your finger
covering the button indicator.
• The LED indicator flashes in white when
you activate the buttons.
FUNCTION* (page 33)
Selects the playback source.
VOL +/–
20
GB
* Hold down FUNCTION on the main unit
for more than 2 seconds, the built-in sound
demonstration will be played back on the
system. If a USB device is connected, the
audio content from the USB will be played
back as sound demonstration. Press x to
stop the demonstration.
Note
During the demonstration, the volume level
may be higher than the volume level you
have set.
E
(USB) port (page 35)
F
(remote control sensor)
G LED indicator
White: Lights up when the main unit is
turned on.
Blue (for BLUETOOTH status):
– System is ready for pairing: Flashes
quickly
– When pairing: Flashes quickly
– NFC device is detected: Flashes
– Connection is established: Lights up