Table of Contents
Advertisement
Inspection and cleaning of the flame monitor
Observations - When removing the flame monitor, hold it by its main assembly; do not pull out the cord.
Remove the burner cover and pull out the
1
flame monitor, and check whether or not
its lens is dirty/foul.
If the lens is dirty/foul, please wipe the
2
surface of the lens with a soft cloth, etc.
until it becomes clear.
Restore the flame monitor, fix burner cover
3
with screws
Inspection of "dirt/dusts" on main unit
Check whether or not dirt/dusts is on or
1
around the heater.
Periodic Inspection
The heater must be checked, if used for a long time. Please ask your dealer to inspect the
1
heater every two (2) seasons.
How to connect the Control device
Uncouple the terminals (A) attached to the
1
tip of white wires that come out of the burner
base.
Connect both male and female terminals,
2
which are uncoupled, to the connecters
(B) of control device.
Observations
・When the heater is controlled by anotherdevice
(such as a thermostat or a timer), the heater could
turn itself on at any time.
If dust is found, clean with a vacuum
2
cleaner or wipe with a soft cloth, etc.
Hide quick links:
Advertisement
Table of Contents
