Creative Sound blaster wireless music User Manual page 58

What do I do when the System menu on my RF Remote displays the <No
Server> message?
• Make sure Wireless Music Media Server is running on your computer. To launch
Wireless Music Media Server, click Start
Creative Wireless Music
Media Server icon on your computer's Taskbar when Wireless Music Media
Server is running. The Taskbar is usually located at the bottom of your desktop.
• Make sure your computer and your Receiver are within transmission range of
your wireless router or access point.
• Make sure your Receiver is running on the same wireless network as Wireless
Music Media Server. For more information, see "How do I know if my Receiver is
connected to my wireless network?" on page B-3.
• If you are using a static IP address, make sure that there is no IP address
conflict with another computer or device.
If the <No Server> message still appears after you have gone through the above
checks, you can:
• Close and then launch Wireless Music Media Server on your computer.
• Press the Power button on your RF Remote to set your Receiver to standby and
then press it again to turn on your Receiver.
• Restart your Receiver. For more information, see "Restarting Your Receiver" on
page 4-6.
How do I reset my RF Remote?
Remove your RF Remote's batteries, and then re-insert them.
Why does the LCD of my RF Remote go blank after a few seconds?
This is a power saving feature of your RF Remote. Pushing any button on the RF
Remote will display the menu options on the LCD again. Note that pushing any of
the blue buttons on the RF Remote will immediately activate the Receiver. For
example, if you press the Play button, playback will start.
→
Programs or All Programs
→
Media Server. You will see the Wireless Music
→
Frequently Asked Questions B-7