Haier HW60-12829 User Manual page 31

Hide thumbs Also See for HW60-12829:
Table of Contents

Advertisement

Do not use a multiple socket extension cord. A separate earthed socket is required which
shall be accessible at all times.
If the mains cord becomes damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified person with a lead of the same type and rating to avoid a hazard.
Never remove the plug from the socket by pulling on the cord, always grasp the plug.
The door may get hot during use,do not touch it and keep children away whilst the machine
is operating.
Never open the detergent drawer while the machine is running.Hot water and detergent m-
ight be ejected.
When installing the product, make sure the mains cord is not trapped or twisted.
WARNINGS:
This appliance is intended for domestic use only,commercial or any other use may invalidate
the warranty and might be dangerous .
Never touch or operate the machine with wet hands or when bare footed.
Do not put the machine on a carpet that can block the ventilation slots on the bottom of the
unit.
Do not install this machine outdoors or in a damp place or expose it to rain.
Do not install this product near a heat source or in direct sunlight.
Do not place any object on the machine when it is operating.
This appliance must be earthed.
If you are disposing of an old appliance,disable the door lock to avoid entrapment of children
when playing and cut off the mains cord close to the machine.
The appliance must be connected to a 220-240 volts 50 cycle AC supply by means of a three
pin socket, suitably earthed and should be protected by a 13 amp fuse in the plug.
The appliance is supplied with a standard 13 amp 3-pin plug fitted with a 13-amp fuse.Should
the fuse require replacement, it must be replaced with a fuse rated at 13 amps and approved
to BS1362.
If the mains plug is unsuitable for the socket outlet in your home or is removed for any other
reason, then the cut off plug should be disposed of safely, do not insert the cut off plug into a
mains outlet to
prevent the hazard of electric shock. Remove the fuse before disposal.
There is a danger of electric shock if the cut off plug is inserted into any 13-amp socket outlet.
WATER CONNECTION
The product should be connected to the water main using new hose sets, old hose sets should
not be reused.
The water pressure must not be less than 0.03MPa.
Connect to the water main using a standard 3/4 inch threaded tap outlet.
31
31

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents