10-Installation - Haier HW60-12829 User Manual

GB
10.1 Preparation
Take the appliance out of the packaging.
Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environmen-
tally friendly manner.
10.2. OPTIONAL: Adjusting the bottom cover
board
cium-plastic board (A) The board is used for reducing
noise after covering the bottom of the cabinet.
Only Model HW80-/HW100:
There is also a felt (B) in the package.
1. Past the felt on one side of the plastic board
(Fig. 10.2).
2. Lay the washing machine down to its side, port-
hole pointing upwards, bottom side towards op-
erator and unscrew the four feet.
3. Place the calcium-plastic board.
Only Model HW80-/HW100:
The felt is pointing inside the appliance.
Screw the feet through the four holes on the
upright again.
10.3 Remove the transportation bolts
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1. Remove the back cover (Fig. 10-3.1).
2. Remove all 4 bolts on the rear side and take out
plastic spacers (A) from inner side of the machine
(Fig. 10-3.2).

10-Installation

1.
-
B
A
WARNING!
The washing machine is heavy u-
se appropriate lifting methods w-
hen fitting the bottom cover.
10-3.1
10.2
2.
3.
10-3.2
A
25