Cleaning Vac Filter; Wet/Dry Vac - RIDGID WD1665 Owner's Manual

Maintenance (continued)
6. Replace foam pad holder on blower
with the tabs away from the blower.
Reinstall foam pad under the tabs of the
holder.

Cleaning Vac Filter

Your filter should be cleaned often to main-
tain peak vac performance.
Be sure to dry the filter before storing or
picking up dry debris.
IMPORTANT: After cleaning, check the fil-
ter for tears or small holes. Do not use a fil-
ter with holes or tears in it. Even a small
hole can cause a lot of dust to come out of
your vac. Replace it immediately.
NOTE: The filter is made of high quality
paper designed to stop very small particles
of dust. The filter can be used for wet or dry
pick up. Handle the filter carefully when
removing to clean or installing it. Creases in
the filter pleats may occur from installation
but will not affect the performance of the fil-
ter.
Removal
To remove the filter for cleaning or replace-
ment, unscrew the filter nut from the filter
cage, remove filter plate and lift off filter.
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall the
filter before using the vac for dry material
pickup.
CAUTION: Do not remove the filter
cage or float. It is there to shut off air-
flow when the drum is full of liquids.
Dry Filter
1. Light cleaning of some dry debris can
be accomplished without removing the
filter from the vac. Simply slap your
hand on top of the lid while the vac is
turned off.
2. Clean the filter in an open area. Clean-
ing SHOULD be done outdoors and not
in the living quarters.
7. Reinstall intake shield and 3 screws.
The unit is ready for use.
3. Remove filter from vac. Gently tap the fil-
ter against the inside wall of your dust
drum and the debris will loosen and fall.
4. For thorough cleaning of dry filter with fine
dust (no debris) you may run water
through it as described under "Wet Filter".
Wet Filter
Remove filter from vac, run water through
the filter from a hose or spigot. Take care
that water pressure from the hose is not
strong enough to damage filter. Remember:
To dry a filter quickly, reinstall the filter on
the vac and allow the unit to run for 10 min-
utes. The clean air rushing through the filter
will dry it.
Installation
Refer to "Filter Assembly".
Allow the filter to dry before reinstalling and
storing the vac.

Wet/Dry Vac

To keep your Wet/Dry Vac looking its best,
clean the outside with a cloth dampened
with warm water and mild soap.
To clean the drum:
1. Dump out debris.
2. Wash drum thoroughly.
3. Wipe out with dry cloth.
WARNING: To assure product
SAFETY and RELIABILITY, repairs
and adjustment should be performed
by Authorized Service Centers,
always using RIDGID replacement
parts.
NOTE: To quiet noisy casters put a drop of
oil on the roller shaft.
12