Ricoh G1168604A Setup Manual page 67

Installing Options
Q
Align the power cable to the left side groove of the duplex unit, and then
slide the duplex unit in until it is connected to the printer.
If the duplex unit is not attached, this step is not necessary.
❒ After finishing installation, you can check the Bluetooth interface unit is
properly installed: Print the configuration page from the "List/Test Print"
menu. If it is installed properly, you will see "Bluetooth" for "Controller Op-
tion".
❒ If the Bluetooth interface unit is not installed properly, repeat the procedure
from the start. If you cannot install it properly even after reinstallation, con-
tact your sales or service representative.
For printing the configuration page, see p.32 "Test Printing".
67