Ricoh G1168604A Setup Manual page 49

Installing Options
❖ 1394 Interface Cable (6 pins x 4 pins)
❖ 1394 Interface Cable (6 pins x 6 pins)
B
Turn off the power of the printer, and then unplug the printer's power ca-
ble and the interface cable.
C
If the duplex unit is attached, push down the lever on right side ( ) and
pull out the duplex Unit until it stops ( ).
If the duplex unit is not attached, go to the following steps.
D
Remove the two screws holding the controller board in place.
❒ Use a coin or similar object if the screws do not turn easily.
49