Husqvarna 390XP Workshop Manual page 50

Crankcase and crankshaft
18.4 Seals
1. To replace the seals on the crank shaft, remove the
following parts first:
On the flywheel side:
• Starter
• Flywheel
• Generator, where appropriate
On the clutch side:
• Chain and bar. Refer to Operators manual.
• Chain guide plate
• Centrifugal clutch
• Oil pump
2. Pull out the seal with the seal ring extractor tool
(Refer to pos. 7 "3 Service tools" on page 8) or
using a flat screwdriver. See fig. 15 and 16.
3. Tap in the new seal with the drift. See fig. 17.
Install the parts. Refer to the disassembly instructions in
the chapter "Crankcase and crankshaft".
50 - English
Fig. 15
Fig. 16
Fig. 15
Fig. 15
Fig. 17
Fig. 16
Fig. 16