Husqvarna 390XP Workshop Manual page 49

4. Place the guide pegs in the crankcase half of the
clutch side, and grease in and insert the gasket. See
fig. 12.
5. Use tool (Refer to "3 Service tools" on page 8,
Pos. 20) and pull on the crankcase half of the fly-
wheel side. Pull until the gasket is clamped between
the crankcase halves. See fig. 13.
6. Fit the six bolts. Tighten them alternately. Tighten
them finally to 8 Nm. See fig. 14.
7. Cut the gasket at the level of the cylinder's seating
plane.
8. Fit the carburettor space bottom with the four bolts.
Tighten the bolts with correct torque (Refer to "4
Service data" on page 10).
9. Assemble the following parts:
A. Tank unit
B. Piston and cylinder
C. Muffler
D. Carburettor
E. Lubrication system
F. Centrifugal clutch
G. Electrical system
H. Starter
I. Chain and bar. See Operator's manual.
10. If a new crankshaft is fitted the chainsaw must be
run for 3-4 hours with the carburettor set to its basic
settings (H=1/4 and L=1/4 turn). Refer to Carburet-
tor chapter.
Fig. 12
Fig. 12
Fig. 12
Fig. 12
Fig. 13
Fig. 13
Fig. 13
Fig. 13
Fig. 14
Fig. 14
Fig. 14
Fig. 14
Crankcase and crankshaft
English - 49