Orange Pi RK3399 User Manual page 17

Orange Pi User Manual
2) Enter into Flashing Mode
Type-A Connect to PC

Press on Recovery key of Orange Pi RK3399

Type-C Connect to Orange Pi RK3399, there should be notice on the following :

There would be log information if you connect debug pin.
Insert DC power supply

Since OrangePi RK3399 supports powered by TypeC, power voltage on USB of PC is enough for
flashing image. However, it may not enough to support Orange Pi booting. In that case, we need to
insert DC power supply to make sure the Orange Pi could boot successfully after flashed image.
If need to flash every partition image(*.img) separately, right click Download Image then click

corresponding firmware path. After that click Run, and the right side would show the status of
running.
www.orangepi.org
Shenzhen Xunlong Software Co., Ltd.
14 www.xunlong.tv