Bayou Classic KDS-1 Owner's Manual page 7

5.Attach Hose to Jet Tube – Insert end of hose into threaded hole at the bottom of the jet tube. Wrench tighten
6. Connect Hose Valve Regulator (HVR) to LP Cylinder –
Check that the LP cylinder is upright and the valve is closed by turning
the knob as indicated on the top of the valve until fully closed.
Remove the protective safety cap from the LP cylinder valve and insert
the nipple of the large coupling nut into the cylinder valve outlet
(confirm the coupling nut is centered). Turn the large coupling nut
clockwise by hand and tighten to a full stop. Do not cross-thread, and
do not use tools.
Turn CLOCKWIS E
Wrench Tighten
Upright
position
Hand tighten only
6
Assembled
View
Orifice
Hole
Jet Tube
Make sure Jet Tube is
clean, orifice hole facing
straight up
Make sure valve
is fully closed