For Your Safety Read Before Lighting - EmberGlow CRO18NG Installation & Operation Manual

Hide thumbs

Table of Contents

WARNING

: If you do not follow these instructions exactly, a fire or explosion may result, causing

property damage, personal injury or loss of life.

Improper installation, adjustment, alteration, service or maintenance can cause injury or property

WARNING:

damage. Refer to the owner's information manual provided with this appliance. For assistance or additional

information consult a qualified installer, service agency or the gas supplier.

For installation in a solid-fuel burning fireplace only. The fireplace chimney must have a perman-

WARNING:

ent vent opening to atmosphere of not less than 49.2 square inches, or as determined from the manufacturer's

installation instructions.

The vent opening in the marking above shall be based on a 6-foot high chimney and the appliance in-

NOTE:

put rate as shown under MINIMUM FIREPLACE SIZE on Page 4.

This gas log set is only to be installed and burned in a fully vented fireplace with a fully functional

damper and chimney that is free of any obstructions. The fireplace must be constructed of non-

combustible materials and approved to burn wood.

The smallest or minimum dimension of the chimney flue must be 8 inches in diameter . Do not use an

Energy efficient Gas Log Set if it is smaller than 8 inches. Do not use an Energy Efficient Gas Log Set if

fumes from the burner emerge into the room when the damper is fully open. This indicates that there is

not adequate draft for this log set and it must not be used until the fireplace draft is corrected.

This appliance must be installed with a Damper Stop Clamp (Part #14). When operating this gas log set,

the flue damper must be fully open.

WARNING:

Do not burn wood, solid fuels, or other material in any fireplace fitted with a gas log set.

FOR YOUR SAFETY:

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other ap

pliance.

Do not place clothing or other flammable material on or near the appliance.

A Fireplace screen must be in place when appliance is operating. Unless other provisions are made for

combustion air, the fireplace screen must have openings for combustion air.

Children and adults should be alearted to the hazards of high surface temperature and should be kept

lear to avoid burns or clothing ignition.

The minimum inlet gas pressure for this appliance i s 7" water column for natural gas. The maximun inlet

pressure is not to exceed 10" water column.

This appliance must also be disconnected from the gas supply system by closing its individual manual

shutoff valve during any pressure testing at pressure equal to or less than 1/2 PSIG.

Do not use this appliance if any part has been under water. Immediately call a qualified service

technician to inspect the appliance and to replace any part of the burner system which has been

under water.

FIREPLACE PREPERATION

Professionally clean chimney and fireplace floor of any

combustible material to limit the smell from the system

Open fireplace damper fully and install Damper Stop

Clamp with 1/4x2" set screw (Part 14#). This clamp is

Designed to allow any combustion by-products to vent

(See Fig.2) Should the Damper Stop Clamp supplied

not fit, a permenant damper stop clamp must be inst-

alled that will keep the damper open at a distance of not

less than 1 1/2".

The damper must be in the fully open position anytime

the unit is in operation.

Prior to connecting the gas log set, make sure that the

gas supply to the fireplace is completely shut off.