Safety; Product Identification - EmberGlow VMO24RNGA Owner's Operation And Installation Manual

5. You must operate this log set with fireplace
in place and fully closed. Unless provided by other
means, fireplace doors or screens shall haveopen-
ings for introduction of combustion air.
6. This log set is designed to be smokeless. If logs
ever appear to smoke, turn off appliance and call a
qualified service person.
Note: During initial operation, slight smoking could
occur due to log curing and the burning off of man-
ufacturing residues. You may wish to add more
ventilation by opening a window.
7. To reduce the creation of soot, follow the "Cleaning
and Maintenance" instructions on
8. Do not allow fans to blow directly into the fireplace.
Avoid any drafts that alter burner flame patterns. Ceiling
fans can create drafts that alter burner flame patterns.
Altered burner patterns can increase sooting.
9. Do not use a blower insert, heat
other accessory not approved for use with this log
set.
10. The installation and provisions for combustion and vent-
ilation air must conform with the National Fuel Gas
Codes, ANSI Z233.1/NFPA 54, Air for Combustion and
Ventilation.

SAFETY

Continued
screens
,
page 13.
-exchanger insert or

PRODUCT IDENTIFICATION

Burner Tube
Burner Pan
Figure 1 - Product Identification - VMO24RNGA Shown
11. Do not run log set:
• where combustible materials, gasoline and other
flammable vapors and liquids are used or stored
• under dusty conditions
12. Do not burn solid fuel in the fireplace after installing the log
set. Do not use this log set to cook food or burn paper or
other objects.
13. Log set becomes very hot when in use. Keep children and
adults away from hot surface to avoid burns or clothing
ignition. Log set will remain hot for a time after shut-down.
Allow surface to cool before touching.
14. Carefully supervise young children when they are in
the room with log set.
15. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
16. To help prevent breakage, new logs must be broken-in
(see "Curing Logs" page 12).
17. Turn log set off and let cool before servicing, installing,
or repairing. Only a qualified service person should in-
stall, service, or repair log set.
18. Provide adequate clearances around air openings.
Heat Shield
Control Knob
3