Advertisement
1.0
Parts
1. Feed Table (W-O001669)
2. First Exit Tray (W-O001611)
3. Red Retarder (WRA003116)
4. ON/OFF/MOMENTARY Switch (M-S033064)
5. Antistatic Tinsel (W-A001684)
6. First Fold Table (W-A001602)
7. Upper Paper Guide (W-A001678)
8. Second Exit Tray (W-O001668)
9. Second Fold Table (W-A001604)
7
Figure #2 Exit View
9
2.0 Installation
2.1 Unpacking
Carefully unpack the 1501 letter folder and accessories. Place the 1501 on a flat, level surface where it
will be used. It is necessary to have a clear area behind the folder to place the exit trays. Place all of the
packing material back in the shipping box and store the box for any future shipment of the 1501. Inspect
the 1501 and all accessories for shipping damage.
immediately.
feed table by the paper guides.
2.2 Feed table assembly
The feed table can be installed in the 1501
by following three simple steps.
First-Locate the Feed Table support pins and support bar (see figure
#4).
Second-Place front edge of feed table between side frames at the top
of the machine (see figure #5). Push feed table into folder so that the
cutout areas on the bottom of the feed table fit onto the feed table support
5
Note:
Never handle the
6
Figure #1 Entry View
1
Figure #3 Folder Unpacked
If any damage is found, contact the carrier
Feed table support pin
and support bar; feed
table mounts on these
2
3
4
2
8
Figure #4
Advertisement
