Table of Contents
Advertisement
Quick Links
MCOHome Mini Energy Switch MH-S210-US is a Z-Wave enabled module that can be set in
existing in-wall switches. It supports basic command class, which can report immediate voltage,
current, watt, and energy consumption. It also can act as a repeater in the Z-Wave network. This
product can be included and operated in any Z-Wave network with other Z-Wave certified devices
from any other manufacturers.
US: 120V 60Hz input, 3A max output
Size：51mm (L)*50mm (W)*20.3mm (H)
Load type: Incandescent
IMPORTANT:
A qualified electrician with the understanding of wiring diagrams and knowledge of
electrical safety should complete the installation inside the main circuit box (normally
outside your house)
Read all instructions and documentation and save for future reference
Step1 Preparing
CAUTION: Cut off power supply at circuit breaker or fuse before installation to avoid fire, shock or
death!
1. Remove the wall switch cover plate.
2. Disconnect both wires from the wall switch.
MCOHome Technology Co., Ltd 2013
www.mcohome.com
Mini Energy Switch
MH-S210-US
Introduction
Specifications
Installation Instructions
User Manual
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for MCOHome MH-S210-US
Summary of Contents for MCOHome MH-S210-US
- Page 1 MH-S210-US Introduction MCOHome Mini Energy Switch MH-S210-US is a Z-Wave enabled module that can be set in existing in-wall switches. It supports basic command class, which can report immediate voltage, current, watt, and energy consumption. It also can act as a repeater in the Z-Wave network. This product can be included and operated in any Z-Wave network with other Z-Wave certified devices from any other manufacturers.
- Page 2 3. Connect Load wire to “Load L”. 4. External switch connection：Connect both wires with two terminals of “Switch”. Note： “3V”and“GND”will only be used with MCOHome touch panel. Step3 Mounting In-Wall Box Mount wall switch and cover plate back to the in-wall box.
- Page 3 Grouping identifier and Node ID of association devices. Using “ASSOCIATION_GET” to get the association device’s Node ID, and “ASSOCIATION_REMOVE” to remove the association device. Command Classes COMMAND_CLASS_ASSOCIATION_V1 Command Name ASSOCIATION_SET Grouping identifier 0x01 / 0x02 Node ID Node ID that need to be included MCOHome Technology Co., Ltd 2013...
- Page 4 Configuration value 0x55 Set 0xFF as 0x55 will restore Factory Settings. Pressing and Holding the ON/OFF/PROGRAM button for 15s. Note：If the Factory Settings is restored successfully, INDICATION LED will blink quickly and then become slower. MCOHome Technology Co., Ltd 2013...
- Page 5 MCOHome warrants this product to be free from defects in material and workmanship under normal and proper use for one year from purchase date of the original purchaser. MCOHome will, at its option, either repair or replace any part of its products that prove defective by reason of improper workmanship or materials.
- Page 6 Country and other applicable export regulations. MCOHome Technology Co., Ltd 2013...
Need help?
Do you have a question about the MH-S210-US and is the answer not in the manual?
Questions and answers