Water Filter - Fleetwood Discovery Owner's Manual

ice within 24 hours after the
refrigerator is properly cooled.
Operation:
Hook to city water or turn
‹
on the water pump.
Lower the bail arm to turn
‹
the icemaker on. Raise
the bail arm to turn the
icemaker off.
‹
To Dispense Ice:
‹
Select crushed or cubed ice
by pressing the corresponding
button on the control panel. Press
a drinking glass against the ice
dispenser arm. Keep the glass as
high as possible to catch all ice.
Turn the icemaker off
‹
before travel to prevent
water from spilling during
transit.
NOTE:
Discard the first batch
of ice as it may contain
impurities.
Firmly push inwards on water filter to
release.

Water Filter

The refrigerator is equipped with
a water filter for the ice and water
dispenser. The filter cartridge is
located at the top of the fresh food
compartment. The filter is rated at
a capacity of about 200 gallons.
The filter element is installed at the
factory, so no initial installation
is required. A monitoring system
alerts the user when filter
replacement is necessary. The
Filter Status light, located on the
control panel, will illuminate when
water or ice is dispensed. The light
will change color depending on
condition of the water filter.
Green: Filter is operating within
specified life cycle.
Amber: Filter is approximately
80% used.
Red: Filter is completely used.
Replace as soon as possible.
Water Filter Replacement:
Monitor the Filter Status light
on the control panel to determine
water filter replacement. Also
replace the water filter after
extended periods of non-use.
031282h
Discovery, Discovery LXE, Pace Arrow, and Pace Arrow LXE
Filter Removal:
Turn the icemaker off (power
switch is located on the icemaker).
Firmly press the filter inward to
release the filter. Pull the filter
cartridge straight out of the filter
housing. A small amount of water
may leak from the filter cartridge.
Do not operate the water or ice
dispenser without the filter in
place.
Filter Installation:
Note cartridge index position
and insert new cartridge in same
position. Firmly push in the new
cartridge until it locks into place.
Turn the icemaker on:
Dispense water into a glass.
Check the filter housing for leaks.
The Filter Reset button is located
on the water and ice dispenser
control panel. Press and hold the
Filter Reset button for 10 to 15
seconds to reset the monitoring
system.
Priming the Water System:
Prime the water system after
changing the water filter and
whenever the water source is
changed. Ensure the water supply
valve is open. The valve is
located in the outside refrigerator
compartment. Press and hold a
drinking glass against the water
dispenser arm until water flows.
Sputtering is normal as air is
purged. Allow water to flow for
three minutes to flush the system
of air and impurities.
NOTE:
The dispenser
automatically shuts off
after three minutes of use.
Release and depress the
dispenser arm to reset.
84