Fleetwood Discovery Owner's Manual page 102

Open panel to access
‹
manual controls.
Set the On/Off switch
‹
to the (I) position to use
manual controls. Position
(II) is for use with a remote
control (not all units).
Flame Action:
Turn the flame action
‹
control knob to adjust
flame speed.
Light Dimmer Control:
Turn the knob to increase
‹
or decrease brightness of
flame and embers.
Heater On/Off switch:
Supplies power to heating
‹
element when main On/Off
switch is On.
Heater Thermostat
Control:
Turn the thermostat control
‹
clockwise to increase
temperature setting or
counterclockwise to
decrease temperature
setting.
Thermal Over-
temperature Switch:
The fireplace is equipped
‹
with a thermostat to
control room temperature.
In the event the fireplace
overheats, an automatic
over-temperature switch
will turn the fireplace off.
The fireplace can be reset
‹
by switching the On/Off
switch to off and waiting
five minutes before turning
the fireplace back on.
CAUTION:
Discontinue use and
contact a service technician
if frequently resetting the
fireplace.
Discovery, Discovery LXE, Pace Arrow, and Pace Arrow
Light Bulb Replacement:
Light bulbs should be replaced
when a section of the flame is
dark or when clarity and detail
diminishes. Two bulbs at the top
of the opening illuminate the log
exterior. Four bulbs under the log
simulate flames and embers. It is
recommended to replace all bulbs
as a set.
Remove the trim by pulling
‹
straight forward.
Hold glass in place while
‹
removing retaining top
clip.
Lift glass out and store in a
‹
safe place.
WARNING:
To reduce the risk of fire
or electric shock, turn
off circuit breaker before
maintenance or cleaning.
CAUTION:
Use care when handling
the glass. Safety glass may
break if bumped, struck or
dropped.
NOTE:
Do not exceed 60 watts per
bulb. Verify brand and size
of bulb before obtaining
replacements. Allow at least
five minutes for bulbs to
cool before touching.
TIP:
Replace all bulbs if they
are close to the end of rated
life.
Dishwasher controls
030979c
101