Fleetwood Discovery Owner's Manual page 138

non-dissolving items into
the toilet. Facial tissue,
wet strength tissue, paper
towels or an excess toilet
tissue can clog the tank or
termination valve.
Water Saver Flush:
Press and release left
‹
button. This mode is
recommended for flushing
liquids and small amounts
of toilet paper only.
Normal Flush:
Press and release right
‹
button. This mode is
recommended for flushing
solids and toilet paper.
Empty Bowl:
Press both buttons
‹
simultaneously and release.
This empties the bowl and
leaves it dry for travel.
Press either button once to
‹
add water, run motor, and
return to normal use.
Programming the Water Level:
The water level in the bowl can
be programmed to different levels.
The minimum recommended level
is ½" above the bowl out fall hole.
After changing water sources such
as city water to the water pump,
the water level may need to be
adjusted.
Press both buttons on the
‹
toilet control panel and
hold.
LEDs will flash indicating
‹
the toilet is in program
mode.
Release buttons to set the
‹
level of standing water in
the bowl.
Holding Tank Level Sensors:
The toilet system has tank level
sensors mounted on the outside
of the black tank. On the toilet
control panel is a water icon
located in the bottom right corner.
Water Icon Not Lit:
Toilet system is off, in
‹
sleep mode or not receiving
power.
Water Icon Lighted Green:
Toilet system is on and the
040466c
‹
holding tank is between
empty and half full.
Water Icon Lighted Yellow:
Toilet system is on and the
‹
holding tank is at least half
full.
Water Icon Lighted Red:
Discovery, Discovery LXE, Pace Arrow, and Pace Arrow LXE
Toilet system is on and the
‹
holding tank is full.
Full Tank Lockout:
To prevent overfill or
‹
flooding, the toilet will
not flush when the system
senses a full tank. This
occurs when the Water Icon
is red.
Emergency Override:
If the tank is full (Water Icon
is red) and an emergency flush is
needed, do the following:
Press and hold either flush
‹
button for 6 seconds to
flush toilet.
137