Changing Power-Save Mode Settings (Power Save) - Ricoh Caplio RR30 Operation Manual

Changing Power-Save Mode Settings (POWER SAVE)

You can reduce the power consumption of the LCD Monitor and extend the life of your batteries.
At the time of purchase, Power-Save Mode is set to [OFF].
Possible Settings
OFF (Power Save Mode Inactivated) Set at purchase
ON (Activate Power Save Mode)
To change the Power-Save Mode, follow the
steps below.
Turn the Mode Dial to
The Setup Screen appears.
If you have activated Power Save mode, power consumption will be less, but there are the following limitations.
• The display on the LCD Monitor will turn off. Press the
the LCD Monitor Display on, and then press them again to turn the display off. You cannot turn the LCD
Monitor Display on/off by pressing the
may be slower.
• It works only in Shooting Mode. It does not work in Playback Mode.
(Setup Mode).
(Self-timer),
96
Chapter 1 / Section 6 Changing Camera Settings
Press the button to select [POWER
SAVE].
Press to select the desired setting.
This setting will be used until you change it.
(Quick Review) button or the
(Flash) or (Macro) buttons.Processing time
button to turn