Adjusting.the.draw-Out.amount.of.the.looper.thread; Replacement.of.gauge.parts - JUKI MH-486-5 Instruction Manual

. 2 4..ADJUSTING.THE.DRAW-OUT.AMOUNT.OF.THE.LOOPER.THREAD

WARNING.:
To.avoid.possible.personal.injury.due.to.abrupt.start.of.the.machine,.turn.off.the.power.to.the.machine.and.check.to.be.sure.that.the.
motor.has.totally.stopped.rotating.in.prior.

. 2 5..REPLACEMENT.OF.GAUGE.PARTS

WARNING.:
To.avoid.possible.personal.injury.due.to.abrupt.start.of.the.machine,.turn.off.the.power.to.the.machine.and.check.to.be.sure.that.the.
motor.has.totally.stopped.rotating.in.prior.
The standard amount of looper thread is drawn out when looper
thread draw-out lever 1 is spaced 3 mm from the thread path
hole in cam thread guide 2 immediately before the thread
trimmer is actuated. Loosen nut 3 and make adjustment by
moving cam thread tension release slide block 4 to the right
or left.
For certain types of needle, the looper thread may slip off the
looper. In such a case, make adjustment so that a longer thread
is drawn out.
– 12 –