RHINO 1640 Operator's Manual page 42

5. Set parking brake. Rotate parking stands from
storage position by removing lynch pins and
clevis pins. Reinstall clevis pins and lynch pins
when parking stands are in operation position
(See Figure Asm-L-0001).
6. Remove lynch pins and 1" hitch pins from
loader upright.
7. Start tractor engine and release brakes. Retract
bucket cylinders to allow parking stands to con-
tact ground.
It is important not to put excessive weight on parking stands with lift cylinder retraction.
Damage may result.
8. Extend lift cylinders 6" to 8" to rotate top of
loader uprights forward out of the mount, allow-
ing tractor to be pushed rearward. Retract
bucket cylinders until lower loader upright pins
clear mount pin saddles and front tires (See
Figure Asm-L-0003).
9. Move tractor rearward approximately 6", being
certain not to stretch hydraulic hoses.
10. Stop tractor engine and set parking brake.
Relax lift cylinders and bucket cylinders by
moving each control lever in both directions.
Disconnect hydraulic hoses from tractor.
11. Start tractor engine and release brakes. Slowly
back tractor out of loader.
1640-1645 01/11
© 2011 Alamo Group Inc.
ASSEMBLY
Assembly Section 3-8