Table of Contents
Advertisement
water cassette
SOFT / SOFT-ECM
INFRARED REMOTE CONTROL
INFRARED REMOTE CONTROL FOR SOFT RC AND SOFT-ECM RC MODEL
Timer
Fan only
Heat
Turn system ON / Send changes
NOTE:
FOR SOME FUNCTIONS COULD BE A DELAY OF ABOUT 5 SEC. BETWEEN
THE SENDING SIGNAL FROM THE INFRARED REMOTE CONTROL AND
THE SETTING OF THE UNIT
OPERATION OF INFRARED REMOTE CONTROL
CLOCK ADJUSTMENT
- Press the [Select] button – "CLOCK SET" will flash.
- Press the [+] or [-] buttons - the hours will flash.
- Adjust the hours using the [+] or [-] buttons.
- Press the [Select] again - minutes will flash.
- Adjust the minutes using the [+] or [-] buttons.
- Press the [Select] again to return to normal display.
- Press the [On/Send] button to send information to the unit.
ON/OFF DAILY TIMER
Start Time
- Press the [Select] button twice – "PROGRAM & START" will flash on display.
- Press the [Select] button - the hours will flash.
- Adjust the hours using the [+] or [-] buttons.
- Press the [Select] button - the minutes will flash.
- Adjust the minutes using the [+] or [-] buttons.
Stop Time
- Press the [Select] button – "PROGRAM & STOP" will flash on display.
Vers. 2015-3
Active
Not active
Modes display
Cool
Auto
Turn system OFF
Clock adjustment
Real time clock
Temperature scale
Set-point display
Fan speeds display
Swing blades display
Fan speed selection
Mode selection
Set-point adjustment
- Press the [Select] button - the hours will flash.
- Adjust the hours using the [+] or [-] buttons.
- Press the [Select] button - the minutes will flash.
- Adjust the minutes using the [+] or [-] buttons.
- Press the [Select] button - the TIMER will blink
- Select TIMER ON (
) or OFF (
- Press the [On/Send] button to send the information to the unit.
EMERGENCY ON/OFF BUTTON
The IR receiver contains an [On/Off] emergency button which can be used for
turning the system ON and OFF when the IR remote control is not in hand.
The [On/Off] button should be pressed for more than 3 seconds and until the
unit beeps (but not more than 10 seconds). Once pressed, the unit will turn ON
or OFF.
When turned ON using the emergency button, the unit will operate in Auto chan-
ge over mode using preset set-point temperatures for heating (21°C) and coo-
ling (24°C). The fan will run in medium speed.
17
INSTALLATION, OPERATION
AND MAINTENANCE MANUAL
Low
High
Medium
Auto
Manual swing
Auto swing by mode
Pic. 26
) using the [+] or [-] buttons.
Advertisement
Table of Contents
